Bedienungsanleitung Cadac 6530L1 - Camp Chef LP (Seite 5 von 7) (Englisch)

684181

Zoom out

Zoom in

Vorherige Seite

1/7

Nächste Seite

5. Fitting and Changing the Hose and Gas Cylinder

• Before tting the regulator to a gas container, ensure that the seal on the regulator is in position and in good condition.

This should be done on every connection.

• Ensure that the gas container is tted or changed outdoors, away from any source of ignition, such as naked ames or electric res and

away from other people.

• Making sure that the gas container is kept upright, screw the regulator onto the gas container until it is fully engaged. Do not over tighten.

• If there is a leak on your appliance (smell of gas), take immediately into a ame-free location where the leak may be detected and

stopped.

If you wish to check for leaks on your appliance, do it outside using soapy water only, which is applied to the joints. A formation of

bubbles will indicate a gas leak.

• Check that all the connections are securely tted and re-check with soapy water. If you cannot rectify the gas leak, do not use the

appliance. Contact your local CADAC stockist for assistance.

• When changing a gas container close the cylinder valve and then the appliance Valve (see Figs. 1 and 2). Making sure the ame is

extinguished, unscrew the regulator. Re-t a full gas container following the same precautions as described above.

Fig. 8

6. Using the Appliance

• This appliance must be used outdoors only!

• When in use, protect from wind for optimum performance.

• Do not move the unit whilst hot. The use of protective gloves is

recommended.

• CAUTION: Accessible parts may become very hot. Keep young

children away from the appliance.

• To pack away, let the unit cool. After cleaning,

Fold the appliance as described is section 3 above.

Fold over the lid of the bag, and zip it closed. (Fig 8)

• Keep the appliance in its Carry Bag when not in use, as this will

prevent the ingress of dirt or insects which may affect the gas ow.

• When attempting to light the appliance, make sure that the gas

supply from the cylinder is open prior to turning on the gas supply to

the appliance.

•

Using the control knob

The control knob is tted with two positive stop positions, one at

low, and one at Ignite / High. This limits the adjustment of the

ame to between these two points.

Lighting up using the Piezo Igniter

• To light up the appliance using the piezo igniter, push in and turn

the control knob in an anti-clockwise direction until you hear a

click. If the gas does not ignite on the rst spark, push in, and

turn the control knob fully clockwise. Try again, by pushing in and

turning the control knob anti-clockwise until you hear a click. If the gas has not ignited in the rst two to three seconds you should

close the control valve by pushing in the control knob, and turning it fully clockwise. Wait approximately thirty seconds to let any

accumulated gas within the burner pan assembly escape. Repeat the above process if necessary until the ame ignites. The ame

should normally light up within the rst one or two seconds.

Lighting up using a BBQ lighter

• When starting cold, the appliance may be lit from the top prior to tting the desired cooking surface onto the fat pan. When lighting up

a hot appliance however, it is recommended that this be done by sticking barbecue lighter through one of the Vent Holes underneath

the Burner, until it is in line with the burner (DO NOT place the BBQ lighter through the large hole directly underneath the burner).

Ignite the BBQ lighter. Whilst the BBQ lighter is lit, push in and turn the control knob anti-clockwise to light the burner.

• Use the control knob to adjust the ame intensity to the desired level by turning the knob clockwise to decrease the ame and anti-

clockwise to increase the ame.

• When not in use disconnect the appliance from the gas supply.

• WARNING: Do not use any cooking surfaces on a high ame setting for more than 10 minutes as this can damage the non-stick

coatings.

7. Cooking Options

• There are three available cooking options with your Camp Chef appliance. These are:

Grilling: This cooking option is ideal for grilling of chicken, sausages, chops, kebabs, sh or vegetables. For this type of cooking, place the

grill plate onto the pot stand.

503-0573 LEV12 (6530L0, 6530L1) Camp Chef LP - User Manual - (EU + SA).indd 4 15/08/2017 13:09:36

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Cadac 6530L1 - Camp Chef LP Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Cadac 6530L1 - Camp Chef LP

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info