Bedienungsanleitung Cadac 8309 - Paella braai (Seite 7 von 9) (Englisch)

684184

Zoom out

Zoom in

Vorherige Seite

1/9

Nächste Seite

5. ASSEMBLY INSTRUCTIONS

Ÿ Note: The hose and regulator are not supplied. For details contact your local stockist.

Ÿ I 3B/P (30), I 3+ (28-30/37) and I 3B/P (37),

Appliance categories:

(DK, FI, NO, NL, SE, AT, DE, BE, ES, FR, IE, IT, PT, GB, CH)

On the other end, attach a suitable 30mbar low-pressure

(I3B/P (30) : 30mbar Butane/Propane configurations regulator; I3+(28-30/37): 30mbar Butane

regulator or 37mbar Propane regulator); I3B/P(37): 37mbar Butane/Propane configurations

regulators). Again making sure that the hose is well seated. The type of hose used shall

comply with the relevant EN standard and locate requirement. In South Africa the regulator

used must comply with SABS 1237.

Ÿ I 3B/P (50) Appliance category: (AT, DE)

Screw a Hose with the correct threaded fittings on each end, onto the left hand ¼“ BSP

thread of the Valve (O) (Fig.4). Attach a suitable 50mbar low-pressure regulator on the other

end of the hose. The hose used must comply with DIN 4815 part 2 or equivalent.

Ÿ The hose length should be no less than 800mm and shall not exceed 1.5m.

Check the expiry date on the hose and replace when necessary or when national conditions

require it.

Ÿ Do not twist or pinch hose. Do not route the hose in any manner that will cause it to come

into contact with any surfaces that would

become hot during use.

Ÿ Before fitting your gas cylinder ensure (Section 7),

that the Valve (M) is in the OFF position by turning

the Control Knob (K) clockwise to its stop position.

(See Fig.8 a, b)

Ÿ Fit the Burner Pan(F) onto the Stem(H), and ensure

is sealed properly.(Fig 5)

6. FITTING AND CHANGING THE

GAS CONTAINER

Ÿ Before fitting the regulator to a gas container, ensure

that the seal on the regulator is in position and in

good condition. This should be done with every connection.

Ÿ Ensure that the gas container is fitted or changed in a well-ventilated location,

preferably outdoors, away from any source of ignition such as naked flames or

electric fires and away from other people.

Ÿ Making sure that the gas container is kept upright, screw the regulator onto the

container until it is fully engaged. Hand-tighten only.

Ÿ If there is a leak on your appliance (smell of gas), take it outside immediately into a

well-ventilated flame-free location where the leak may be detected and stopped.

If you wish to check for leaks on your appliance, do it outside using soapy water

only, which is applied to the joints. The formation of bubbles will indicate the gas

leak.

Ÿ Check that all the connections are securely fitted and re-check with soapy water.

If you cannot rectify the gas leak, do not use the appliance. Contact your

local CADAC stockist for assistance.

Ÿ When changing a gas container, firstly close the container valve (if fitted) and then

turn the Control Knob (K) clockwise to its stop position. Ensuring that the flame is

extinguished, unscrew the regulator. Refit a full container following the same

precautions as described above.

Fig. 3

Fig. 5

Fig. 4

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Cadac 8309 - Paella braai Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Cadac 8309 - Paella braai

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info