Bedienungsanleitung Caliber CAM 030 (Seite 4 von 18) (Deutsch, Englisch, Holländisch, Französisch, Spanisch, Schwedisch)

699227

Zoom out

Zoom in

Vorherige Seite

1/18

Nächste Seite

CAM 030

English

Installing the CAM030

Look for a location that will give you the best view behind the vehicle. This should not be directly next to or under a reverse/

backup lamp as it may blind the camera at night. Avoid license plate lamps as well as they too can blind the camera at night.

Determine which casing option (A/B/C) is most suitable for your vehicle.

Wire the camera’s power wire to the vehicle’s reverse lamp:

a) Locate the reverse lamp in the tail light assembly

b) Using a crimp connector or by soldering attach the red wire to the positive 12 volt wire from the reverse lamp. This should

only have power when the car is in reverse gear and the white lamp illuminated. Attach the black wire to the Ground

(Negative 12 Volts only).

Run the extension cable to the location of the monitor/head-unit (not included) and connect the other end of the extension

cable to the camera. Yellow RCA connected to the Video/CAM input.

Blue wire:

Cut to turn off the guiding lines*

White wire:

Cut to horizontally mirror the image on screen*

*Turn the camera OFF and ON again for the cut to take effect

Head-unit

On some head-units you need to connect the 12V red wire to the ‘back cam’ wire on your head-unit. The screen will

automatically turn ON when reversing.

Warnings

The product is intended to assist in safe driving and to allow

the driver to have a broader rear view while the vehicle is in

reverse. You, as the driver, are solely responsible for the safe

operation of your vehicle and the safety of your passengers

according to local trafc regulations. Do not use any features

of this system to the extent that it distracts you from safe

driving. Your rst priority while driving should always be the safe

operation of your vehicle. Caliber Europe BV cannot accept any

responsibility whatsoever for accidents resulting from failure to

observe these precautions or safety instructions

1. This product utilizes high voltage. Any unauthorized

modications or damage to the product may result in

electrical shock. Handle all components with care. Inspect

regularly for damage to components and cabling.

2. You are responsible for ensuring that the installation of this

product does not void or affect the vehicle manufacturer’s

warranty. Caliber Europe or its subsidiaries are not liable

in full or in part for improper installation resulting in loss

or damage to your property, or for voiding all or part of the

vehicle manufacturer’s warranty.

3. Do not apply excessive force to any of the components

contained within this kit. Excessive force used before,

during or after installation that results in a damaged or non-

functional part will void all warranties.

4. Please follow the procedures in this installation manual.

Improper installation or modication of this product will void

all warranties.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Caliber CAM 030 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info