8
Connections
Loudspeakers
Check the impedance of your speakers. When using a pair of speakers,
you can use types with an impedance of between 4 and 8 Ohms.
The red coloured speaker terminals are positive (+) and the black speaker
terminals are negative (-). Make sure correct polarity is maintained at
each speaker connector or the sound can become weak and “phasey”
with little bass.
Using bare wire connections
Prepare the speaker cords for connection by stripping off approximately
10mm (3/8”) or less of the outer insulation. More than 10mm could
cause a short circuit. Twist the wires tightly together so there are no loose
ends. Unscrew the speaker terminal, insert the speaker cable, tighten the
terminal and secure the cable.
Note: All connections are made using standard loudspeaker cable.
Basic connection
The diagram below shows the basic connection of your unit to a
CD player and a pair of loudspeakers.
Right
speaker
Left
speaker
Red
Red
Black
350A
amplifier
CD player
Red
Black
Black Red
Black
Tape connection
The diagram below shows how to connect the amplifier to a tape
recorder or other source with a record and monitor connection. Please
note that either of the tape loop outputs can be used (as they are both
the same signal in parallel).
Right
speaker
350A
amplifier
Tape/MD player
Left
speaker
