3
Pls take care of a suitable workplace, a garage or hall is better than a place outside. The ambient
temperature during sticking the antenna should lie within a temperature between +5˚C to max.+25˚C. If you
work outside avoid direct sunlight!
Always keep to the instructions dealing with chemical products.
Take care of necessary hygienic working conditions.
Important!
Pls absolutely keep to each individual point of mounting instruction!
General:
If the surface of the mounting place is made from unknown material, we recommend a "test sticking". If
necessary we can arrange a material analysis at your cost.
Note:
1. Assure that the roof of your vehicle is able to carry the antenna. If you are not sure pls fix a metal plate
(Alu, appr. 2mm thickness) onto the roof. Pls also ask the vehicle's manufacturer.
2. Pls check completeness of parts.
3. Put the antenna on the selected mounting place on the car roof and adjust if necessary. The mounting
place must be even and no other roof constructions may cover the reception area of the antenna.
Mark the outline of antenna feet with a suitable pen.
In case of problems (e.g. the roof is not even but has a curved form instead) pls call our hotline to
arrange further steps.
4. Replace the antenna.
Clean the mounting place and the antenna feet with the supplied special cleaning fluid "Reiniger1" and
the supplied fleece (pls wear the supplied Latex gloves!).
Grind the marked fixing areas and antenna feet with sandpaper (not too much, the surface must be
rough a little bit only), clean the surface and antenna feet with cleaning fluid 1 again and wait another 10
minutes.
Attention! Now do not touch the cleaned surface any more!
5. Apply (with the help of the wool wiper-pls wear the supplied Latex gloves!) the Primer 2 evenly and thin
onto the cleaned surface and feet. Then pls wait another 10 minutes. Attention! Do not touch the
cleaned surfaces any more!
Close the Primer 2 bottle at once after use.
screw hole
antenna foot
Preparation:
antenna dome
