Bedienungsanleitung Camry CR 2024 (Seite 5 von 76) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Schwedisch, Finnisch)

738813

Zoom out

Zoom in

Vorherige Seite

1/76

Nächste Seite

Plug the unit in and push the switch on (2), the power indicator light (1) will be lighted up. Allow it to heat up for a few minutes. Do not

touch the heated elements during use. After use switch off and plug out the device, let all attachments to cool down before storage.

Straightening Brush attachment:

Use the Straightening Brush on dry hair taking up small strand of hairs at a time. Holding the hair taut and beginning at the roots,

Work smoothly so as to avoid creating a ridge in the middle of the section.

The Crimping Plates “ZIG-ZAG” or the 3D Waveing plates:

Work with dry hair. Take up a section of hair , place it between the plates and then close the plates. Hold the unit closed for about 15

seconds. Release. Next fold the other strand of hairs using the last wave as a guide. Always work from the roots to the ends.

Note! When you are using the appliance, you might see some steam. Do not be concerned , this could the because of evaporation of hair

products (leave-in hair care, hairspray, etc.) or excess water that is evaporating form your hair.

19 & 32 mm Curling Tong attachments:

Comb your dry hair and divide it into equal strands before curling. Press the clamp lever and place the end of the strand between the

clamp and the tong.

Roll the hair around the tong from the ends to the point where you want the curls to begin. Don't let the tong touch your scalp. Hold the

tong in place for 10 to 15 seconds.

To remove hair, press the clamp lever to open. To fix the hair twist, wait until your hair has cooled before handling.

Comb Guide attachment for 19mm curling tong:

For gentler curls – like from hot air brusher - use the comb guide with the 19mm curling tong. Make sure the tong is cool. Slide the comb

guide over the tong.

Take up a strand of hair and roll around the attachment, hold for about 15 seconds and gently unroll. Allow your hair to cool before

combing or brushing.

Spiral Guide attachment:

For tight and well-shaped curls, use the Spiral Guide attachment with the 19mm curling tong.

Make sure the tong is cool. Slide the Spiral Guide over the tong.

Take up a strand of hair of about 2-3cm and roll it carefully around the spiral ,hold for about 15 seconds and unroll it gently.

Allow your hair to cool before styling.

CLEANING AND MAINTENANCE

Once unplugged and cooled, the appliance may be wiped with a damp cloth. Make sure that it is completely dry before plugging it in

again.

Technical Data:

Power:50W

Max Power: 1200W

Voltage: 220-240v ~50/60Hz

move

the brush along the entire length of the hair.

DEUTSCH

To protect your environment: please separate carton boxes and plastic bags and dispose them in corresponding waste

bins. Used appliance should be delivered to the dedicated collecting points due to hazarsous components, which may

effect the environment. Do not dispose this appliance in the common waste bin.

Device is made in class II of insulation.

Device is compliant with EU directives:

- Low voltage directive (LVD)

- Electromagnetic compatibility (EMC)

Device marked CE mark on rating label

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Camry CR 2024 Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info