764893
11
Zoom out
Zoom in
Vorherige Seite
1/12
Nächste Seite
OKANAGAN/SASKATOON/GANDER/MUSKOKA SPAS
Balboa
2 KW
M7 Heater
with amp plug
Any time you change a DIP Switch, other than A1, you must
reset Persistent Memory for your new DIP Switch Settings
changes to take effect. If you do not reset Persistent Memory,
your system may function improperly.
To reset Persistent Memory:
Power down by disconnecting power source from spa.
Put a jumper across J43, covering both pins.
Power up by connecting power source to spa.
Wait until Pr is displayed on your panel.
Power down again.
Remove jumper from J43 (May also move to cover 1 pin
only)
Power up again.
About Persistent Memory and Time of Day Retention:
This system uses memory that doesn’t require a battery to
store a variety of settings. What we refer to as Persistent
Memory stores the lter settings, the set temperature, and the
heat mode.
Persistent Memory is not used for Time of Day. Only models
with a Serial Deluxe panel installed (VS5xxDZ and GS5xxDZ)
can display the time. However, during power loss to the spa,
the system will lose the correct time, and reset to 12:00 PM
when power is restored.
Power Up Display Sequence
Upon power up, you should see the following on the display:
Three numbers in a row, which are the SSID (the System
Software ID). The third display of these numbers is the
Software Version, which should match the version of
your system. For example, if these three numbers are
100 67 38 , that is a VS511SZ at version 38.
Displayed next is: 24 (indicating the system is congured
for a heater between 3 and 6 kW) or 12 (indicating the
system is congured for a heater effectively* between 1
and 3 kW).
24 should appear for all VS models running at 240VAC.
12 should appear for all VS models running at 120VAC, as
well as all GS models. (*A heater which is rated at 4 kW at
240VAC will function as a 1 kW heater at 120VAC.)
Pr will appear to signal the start of Priming Mode.
At this point, the power up sequence is complete. Refer to
the Reference Card for the VS or GS System model of
your spa for information about how the spa operates from
this point on, including how to adjust the Time of Day if using
a Serial Deluxe style panel.
(11)
11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Canadian Spa Company Gander wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info