SETTING UP + INSTALLATION
Remove the polystyrene base and place the machine near
its permanent position (diagram 1).
Carefully cut through the hose retaining clip at the rear of
the appliance (diagram 2).
Unscrews the two top screws A and remove the cover,
sliding it off horizontally (diagram 3).
Remove the cardboard protection.
Unscrews the two tie braces B on the crosspiece (with an H.
19 spanner) and remove the polystyrene spacers under it
(diagram 4).
Please do not fit the 2 tie braces B again!
IMPORTANT: DO NOT REMOVE THE SPACERS ABOVE THE CROSSPIECE.
Replace the cover with the two screws A.
Please ensure when fitting the table top the locating pins are inserted correctly in their slots,
positioned on the side of the cabinet as shown in the diagram 5.
WARNING:
DO NOT LEAVE THE PACKAGING WITHIN REACH OF CHILDREN AS IT IS A
POTENTIAL SOURCE OF DANGER.
Apply the insulation sheet of
corrugated material to the base as
shown in the relevant diagram.
Level the machine by means of the
front feet.
a) Turn the nut clockwise to release
the screw adjuster on the foot.
b) Rotate the foot to raise or lower it until it stands firmly on the
ground.
c) Lock the foot in position by turning the nut anti-clockwise until it
comes up against the bottom of the machine.
1
2
EC Appliance complies with European Directive 89/336/EEC, 73/23/EEC and
subsequent amendments.
Technical data
■
Max. load of dry laundry
■
Water pressure
■
Spin speed
Measurements
■
Width
■
Depth
■
Height
NB: For specifications regarding electrical data, see the data panel on the front of the washing
machine (porthole area) - as shown in diagram above.
3,5 kg
0,05 ÷ 0,8 MPa
1000 rpm
51 cm
43 cm
70 cm
22 23
Fig. 2