Bedienungsanleitung Candy CMM5620SHW (Seite 3 von 15) (Englisch)

466040

Zoom out

Zoom in

Vorherige Seite

1/15

Nächste Seite

02 GB

INSTALLATION

Installation have to be made by qualified personnel. The manufacturer

have no obligation to carry this out. If the assistance of the

manufacturer is required to rectify faults arising from incorrect

installation, this assistance is not covered by the guarantee.

The installation instructions for professionally qualified personnel

must be followed. Incorrect

installation may cause harm or injury to

people, animals or belongings. The manufacturer cannot be held

responsible for such harm or injury.

WARNING! Care must be taken regarding where the appliance is

placed! It can only be installed in a continuously ventilated room.

Electrical connections must always be disconnected before any

repair,

installation or modification.

•Before positioning your appliance, check the properties of the energy

supply (gas type, gas pressure) and make sure that your appliance is

regulated accordingly.

•This appliance must not be connected to the exhaust system of any

equipment running on other fuel.

•The appliance must not be installed near flammable

materials (e.g.

furniture, curtains, etc.)

•This grill(s) should be constructed so that it cannot be closed from

either side and positioned preferably near the floor. Grill(s) must not

be placed across the channels through which combustion gases and

exhausted fumes pass.

•If it is impossible to install grilled air vents

in the room where the

appliance is installed, the air needed can also be supplied from an

adjacent room providing it is not a bedroom or a room where an air

current could cause danger.

ENVIRONMENT THE APPLIANCE SHOULD BE

PLACED

•There must be sufficient natural air ventilation in the room for gas

combustion for the appliance to function correctly.

•The air flow should enter through grilled air vents in the outer walls.

•Air grills must have a cross section of 100 cm² for the passage of air

and for appliances with

a flame safety device. For appliances with no

flame safety device, this cross section should be 200 cm². (Single or

multiple grills can be used)

Emission of Combustion Gases

•Combustion gases from cooking appliances must be released

directly out of doors or via a hood connected to a chimney or flue

(Figure 1)

•If it is impossible to install a hood, an electric extraction fan should be

fitted in a wall or a window opening out of doors (Figure 2)

•Extractor fans should have a capacity of replacing kitchen air 3-5

times per hour.

Figure 1 Figure 2

POSITIONING

This appliance is of the "X" type and it has been designed on the

presumption that the adjacent work tops will be no higher than the

cook top surface.

This appliance is class 2.1

FEET ADJUSTMENT

Your appliance has adjustable feet at the

lower corners of its chassis.

The feet can be adjusted individually with

the aid of a wrench to guarantee that the

oven is perfectly balanced and level, so

that any liquids in the pans is horizontal .

750 mm

20 mm 20 mm

400 mm

200 mm 200 mm

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Candy CMM5620SHW Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Candy CMM5620SHW

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info