PREPARING THE WASH CYCLE 1.- Once the washing is loaded, ensure that the drum doors are properly closed.. 2.- Add detergent and additives, not exceeding the maximum level indicator. • detergent for pre-wash I • detergent for wash programme II • bleach • fabric conditioner SELECTING THE DESIRED PROGRAMMES AND OPTIONS 3.- Turn the programme selector (A) to the desired programme. 4.- Press the key or keys for any options desired (C1, C2, C3). C1 easy iron key This function helps reduce creasing, depending on the programme selected and the type of fabric washed. This works as follows: Synthetics. Intermediate spins during rinses are eliminated. Delicates. Intermediate spins during rinses are eliminated and the machine stops before the final spin, which is a gentle spin. Woollens. Intermediate spins during rinses are eliminated and the machine stops before the final spin. Hand wash. The machine stops before the final spin. Rinses. Intermediate spins during rinses are eliminated. To complete the wash cycle in the Delicates, Hand wash, and Woollens programmes, press the Easy Iron key again: the machine will empty and perform the required spin. To empty machine of water with no spin, cancel the ongoing programme and select the empty programme. C2 extra rinse key The electronic system engaged by this key activates a new special rinse cycle. More water and a combination of drum rotation movements ensure that washing is perfectly rinsed. The key can be activated in Cottons, Mixed, Synthetics, Delicates, Rinse, Woollens, Sportswear and AA40 programmes. C 3 super fast key When this key is engaged programme times are cut by as much as 50 minutes, depending on the wash programme and temperature selected. The key can be activated only in Cottons, Synthetics and Mixed programmes. 5.- Select spin speed if required (B) B spin selector Use this control to select the maximum spin speed within the range for the model of washing machine in question and the programme selected (see programme table). The control can be turned in both directions. Spin speed may be selected at any time during the programme. 6.- Once you have selected the desired options, press the START key (H). The washing machine will start up and one of the time remaining or programme phase lamps (V) will come on. This lamp indicates approximately how much time is left before the wash programme is completed (or wash cycle phase): it will change as the programme progresses. Make sure that the stop/end of cycle lamp is flashing before pressing the start key (H). If it remains on continuously, turn the programme selector to OFF and re-set it to the desired programme. To cancel an option after setting, just press the option key again (the indicator lamp will go out).
To change or cancel a programme once the programme selected has started, proceed as follows: - Hold down the start key (H) until the stop/end of cycle lamp is burning steadily. The programme has been cancelled, and another may be selected. - Select the new programme. - Press the start key (H) again until one of the time remaining or programme phase lamps lights up. - The machine will then run the new programme selected. Programme Pause To pause the wash programme so that more washing can be added, proceed as follows: - Hold down the start key (H) until the option key lamps begin to flash and the time remaining or programme phase lamp lights up. - When the Door Lock lamp goes out (after approx. 2 minutes, or 5 minutes if the machine is equipped with the STOP & LOAD function), open the door and put the additional washing into the drum. - Close the drum door and the lid properly. - Press the start key (H), the time remaining or programme phase lamp will light up and the machine will continue with the programme. When the programme is completed the Stop/End of cycle lamp (S) will come on and the time remaining or programme phase and Door Lock lamps (V and G) will go out.
07-04 / 46001778 EN
For your own safety, set the programme selector to OFF before opening the washingmachine lid and the drum doors to remove the washing.