424325
64
Zoom out
Zoom in
Vorherige Seite
1/86
Nächste Seite
63Troubleshooting
Cannot Send Using Error Correction Mode (ECM)
Errors Occur Frequently While Sending
z Receiving Problems
Cannot Receive a Document Automatically
The Fax Does Not Switch Automatically Between Telephone and Fax
Reception
The document may not have been
loaded correctly into the ADF.
Remove the document, stack it if necessary, and load it into the ADF correctly
(see page 22).
Cause Action
The receiving party’s fax machine may
not support ECM.
If the receiving party’s fax machine does not support ECM, then the document is
sent in normal mode without error checking.
ECM may be disabled. Make sure ECM is on (see <ECM TX> on page 46).
Cause Action
The telephone lines may be in poor
condition, or you may have a bad
connection.
Lower the transmission speed (see <TX START SPEED> on page 47).
Cause Action
The fax may not be set to receive
automatically.
For the fax to receive documents automatically, the receive mode must be set to
<FAX ONLY MODE>, <Fax/Tel Mode>, <DRPD>, or <ANS.MACHINE MODE>
(see page 33). If you have set <ANS.MACHINE MODE>, check that an
answering machine is connected to the fax and that it is turned on with an
outgoing message properly recorded (see page 35).
The fax may have a document stored in
memory.
Print out any documents stored in memory (see page 39).
An error may have occurred during
reception.
z Check the LCD for an error message (see page 73).
z Print the ACTIVITY REPORT and check for an error (see page 48).
The Rear Tray may be empty. Make sure paper is loaded in the Rear Tray (see your setup sheet or page 22).
The telephone line may not be
connected properly.
Make sure all line connections are secure (see your setup sheet).
The machine is under maintenance. /
The machine is sending a fax. / The
machine is printing another document.
Cancel sending, printing, or maintenance as soon as possible.
Cause Action
The fax may not be set to switch
automatically between telephone and
fax reception.
For the fax to switch automatically, the receive mode must be set to <Fax/Tel
Mode>, <DRPD>, or <ANS.MACHINE MODE> (see page 33). If you have set
<ANS.MACHINE MODE>, check that an answering machine is connected to
the fax and that it is turned on with an outgoing message properly recorded (see
page 35).
The fax may have a document stored in
memory.
Print out any documents stored in memory (see page 39).
An error may have occurred during
reception.
z Check the LCD for an error message (see page 73).
z Print the ACTIVITY REPORT and check for an error (see page 48).
The Rear Tray may be empty. Make sure paper is loaded in the Rear Tray (see your setup sheet or page 22).
The sending fax machine may not send
the CNG signal that tells the fax that
the incoming signal is a fax.
Some fax machines cannot send the CNG signal that tells your fax the incoming
call is from a fax machine. In such cases, you will have to receive the document
manually (see page 35).
Cause Action
64

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Canon jx210p wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Canon jx210p

Canon jx210p Bedienungsanleitung - Holländisch - 95 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info