645136

Casio 5418 Seite 4

4
Zoom out
Zoom in
Vorherige Seite
1/6
Nächste Seite
E-24
To perform an elapsed time operation
D
D
D D
A
Start Stop (Resume) (Stop) Reset
To pause at a split time
D
A
A D
A
Start Split
(
SPL
appears in
the upper display.)
Split release Stop Reset
To measure two fi nishes
D
A
D A
A
Start Split
First runner fi nishes.
(
SPL
appears in the
upper display.)
Display time of fi rst
runner
Stop
Second runner
fi nishes.
Split release
Display time of
second runner
Reset
Note
• The Stopwatch Mode can indicate elapsed time up to 23 hours, 59 minutes, 59.99 seconds.
• Once started, stopwatch timing continues until you press
D
to stop it, even if you exit the Stopwatch
Mode to another mode and even if timing reaches the stopwatch limit defi ned above.
1/10
seconds
1/100
second
Elapsed time
measurement stopped
1/10
seconds
1/100
second
Elapsed time
measurement stopped
E-25
Using the Countdown Timer
The countdown timer can be confi gured to start at a preset time and sound an alarm when the end of the
countdown is reached.
To enter the Countdown Timer Mode
Use
C
to select the Countdown Timer Mode as shown on page E-8.
To specify the countdown start time
1. Enter the Countdown Timer Mode.
• If a countdown is in progress (indicated by the seconds counting
down), press
D
to stop it and then press
A
to reset to the current
countdown start time.
• If a countdown is paused, press
A
to reset to the current
countdown start time.
2. Hold down
A
until the minute setting of the current countdown start
time starts to fl ash. This is the setting screen.
3. Use
D
(+) and
B
(–) to change the minute.
• To set the starting value of the countdown time to 60 minutes, set
60'00.
4. Press
A
to exit the setting screen.
Minutes
Seconds
Countdown Timer Mode
Countdown time
Minutes
Seconds
Countdown Timer Mode
Countdown time
E-26
To perform a countdown timer operation
D
D
D D
A
Start Stop (Resume) (Stop) Reset
• Before starting a countdown timer operation, check to make sure that a countdown operation is not
already in progress (indicated by the seconds counting down). If it is, press
D
to stop it and then
A
to reset to the countdown start time.
• An alarm sounds for ten seconds when the end of the countdown is reached. This alarm will sound in
all modes. The countdown time is reset to its starting value automatically after the alarm sounds.
To stop the alarm
Press any button.
E-27
Checking the Current Time in a Different Time Zone
You can use the World Time Mode to view the current time in one of 31 time zones (48 cities) around the
globe. The city that is currently selected in the World Time Mode is called the “World Time City”.
• You also can swap the current World Time City and Home Time City in the World Time Mode (page
E-29).
To enter the World Time Mode
Use
C
to select the World Time Mode as shown on page E-8.
• The current city code and city name will scroll across the upper
display. After that, the city code will remain shown in the upper
display. You can scroll the city code and city name again by pressing
A
.
• The hour, minute, and second hands will indicate the current
Timekeeping Mode time.
To view the time in another time zone
In the World Time Mode, use
D
(East) to scroll through city codes.
• To change the city code to
UTC
, press
B
and
D
at the same time.
Currently selected
World Time City
Hour and minute
Current time in the currently
selected World Time City
World Time Mode
Second
Currently selected
World Time City
Hour and minute
Current time in the currently
selected World Time City
World Time Mode
Second
E-28
To specify standard time or daylight saving time (DST) for a city
1. In the World Time Mode, use
D
(East) to scroll through the available
city codes.
• Keep scrolling until the city code whose standard time/daylight
saving time setting you want to change is shown in the upper
display.
2. To toggle between summer time (
DST
indicator in the lower display)
and standard time (
DST
indicator not displayed), hold down
A
.
• Using the World Time Mode to change the DST setting of the
city code that is selected as your Home City also will change the
Timekeeping Mode time DST setting.
• Note that you cannot switch between standard time/daylight
saving time (DST) while UTC is selected as the World Time City.
• Note that the standard time/daylight saving time (DST) setting
affects only the currently selected time zone. Other time zones are
not affected.
DST indicator
Hold down A
DST indicator
Hold down A
E-29
To swap your Home Time and World Time Cities
1. In the World Time Mode, use
D
to select the city you want to use as your new Home City.
2. To swap, press
A
and
B
at the same time.
$ and %
• This will make the World Time City you selected in step 1 (LON (LONDON)) your new Home City.
• Your previous Home City (TYO (TOKYO)) will be your new World Time City.
E-30
Using the Alarm
You can set fi ve independent daily alarms. When an alarm is turned on,
an alarm will sound for about 10 seconds each day when the time in the
Timekeeping Mode reaches the preset alarm time. This is true even if the
watch is not in the Timekeeping Mode. One of the daily alarms is a
snooze alarm. The snooze alarm will sound every fi ve minutes up to
seven times or until it is turned off.
You can also turn on an Hourly Time Signal, which will cause the watch
to beep twice every hour on the hour.
To enter the Alarm Mode
Use
C
to select the Alarm Mode as shown on page E-8.
• The upper display will show the currently selected alarm number (
AL1
to
AL4
, or
SNZ
), or the hourly time signal indicator (
SIG
).
• When you enter the Alarm Mode, the data you were viewing when you
last exited the mode appears fi rst.
Alarm time
(Hour : Minutes)
Alarm Mode
Alarm number
or SIG
Alarm time
(Hour : Minutes)
Alarm Mode
Alarm number
or SIG
E-31
To set an alarm time
1. In the Alarm Mode, use
D
to scroll through the alarm screens in the
upper display until the one you want to change is shown.
AL1 AL2 AL3
SIG SNZ AL4
2. Hold down
A
until the hour digits of the alarm setting start to fl ash in the lower display.
• This is the setting screen.
3. Press
C
to move the fl ashing between the hour and minute settings.
4. While a setting is fl ashing, use
D
(+) and
B
(–) to change it.
• When setting the alarm time using the 12-hour format, take care to set the time correctly as a.m. (no
indicator) or p.m. (P indicator).
5. Press
A
to exit the setting screen.
To test the alarm
In the Alarm Mode, hold down
D
to sound the alarm.
Alarm ON/OFF
indicator
Alarm ON/OFF
indicator
Operation Guide 5418
4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Casio 5418 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Casio 5418

Casio 5418 Bedienungsanleitung - Deutsch - 6 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info