49687
3
Zoom out
Zoom in
Vorherige Seite
1/5
Nächste Seite
Party timer
A party timer can be connected to connectors 1 and 3 of the FS171 remote control. When these two connectors
are closed by the timer, the controller will be forced to day operation. The big arrow in the LCD will jump to day
operation.
Start up
When all components are connected according to the instructions, the power cord has to be plugged into a
power outlet. The FS171 will accumulate energy. After a few seconds press the reset button with a sharp pointy
tool. Hereafter the clock is ready to be programmed.
For correct functionality, 3 things have to be set to certain values:
• Heating curve
• Switching difference
• Room-influence
Steepness of heating curve (S)
With the potentiometer S on the VS161, the relation between the outdoor temperature and the water flow
temperature can be adjusted.
Switch difference (ΔT )
Also on the VS161 a potentiometer for the ΔT is provided. With this potentiometer, the range of the switch-
difference is set. The switch-difference is defined on top of the heating curve (see bottom graph). This has to be
kept in mind while setting the heating curve S.
The value to choose depends on the type of boiler:
• Cast iron boilers: ΔT between 6 and 8 K.
• Modern boilers with small water contents: ΔT between 10 and 15 K.
From a controlling point of view there are no objections to often switching on and off a modern lightweight boiler.
However, to save life of the boiler, there is minimal firing-time of 2 minutes built in the VAG 4000 controller.
Example
If a water flow temperature of 45°C is wished according to a certain outdoor temperature and S setting, and the
ΔT is set to 6 K, than the boiler will be fired when the water flow temperature falls below 45°C. Thereafter, the
water flow temperature will rise. When the temperature goes above (45+6=) 51 °C, the boiler is switched off. lf
this temperature is reached within the described minimal firing-time (2 minutes), the boiler will be fired for the full
length of the 2 minutes.
3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Cenvax VAG 4000 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Cenvax VAG 4000

Cenvax VAG 4000 Installationsanweisung - Holländisch - 12 seiten

Cenvax VAG 4000 Bedienungsanleitung - Holländisch - 6 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info