555436
2
Zoom out
Zoom in
Vorherige Seite
1/44
Nächste Seite
1
Safety Symbol and Signal Word Review
This garage door opener has been designed and tested to offer safe service provided it is installed,
operated, maintained and tested in strictaccordance with the instructions and warnings contained in this
manual.
When you see these Safety Symbolsand Signal Wordson the following pages,they will alert you to the
possibilityof serious injury or death ifyou do notcomply with the warnings that accompany them. The
hazard may come from something mechanical or from electric shock. Read the warnings carefully.
Mechanical
Electrical
When you see thisSignal Word on the following pages,it will alertyou to the possibilityof damage to
your garage door and/or the garage door opener if you do notcomplywith the cautionary statements that
accompanyit.Read them carefully.
Check the Door
To prevent possible SERIOUS INJURY or DEATH:
l
ALWAYS call a trained door systems technician if garage door binds,sticks, or is out ofbalance.
An unbalanced garage door mayNOT reverse when required.
l
NEVER try to loosen, move or adjustgarage door, door springs, cables,pulleys, bracketsor their
hardware, ALL ofwhich are under EXTREME tension.
l
Disable ALL locks and remove ALL ropes connected to garage door BEFORE installation and
operating garage door opener to avoid entanglement.
To prevent damage to garage door and opener:
l
ALWAYS disable locks BEFORE installing and operating the opener.
l
ONLY operate garage door opener at 120 V,60 Hzto avoid malfunction and damage.
Before you begin:
1. Disable locks and remove any ropesconnected to the garage door.
2. Liftthe door halfway up. Release the door. If balanced,it should stay
in place,supported entirely byitssprings.
3. Raise and lower the door to check for binding or sticking. If your door
binds, sticks, or is out ofbalance, call a trained door systems
technician.
4. Check the seal on the bottom ofthe door. Any gap between the floor
and the bottom of the door must not exceed 1/4 inch (6 mm).
Otherwise,the safety reversal system maynot work properly.
5. The opener should be installed above the center of the door. Ifthere
is a torsion spring or center bearing plate in the way ofthe header
bracket, itmay be installed within 4feet(1.2 m) to the leftor right of
the door center. See page11.
Torsion
Spring
Extension
Spring
OR
Preparation
2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Chamberlain WD832KEV wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info