585149
4
Zoom out
Zoom in
Vorherige Seite
1/10
Nächste Seite
Page 4SKU 96157
For technical questions, please call 1-800-444-3353.
Do not allow the Black and Red clamps to touch. 17. Injury to the operator or prop-
erty damage can occur if this happens.
For emergency use only. 18. Do not use this system in the place of a vehicle battery.
Only use to jump start the vehicle.
Lead acid batteries generate additional hydrogen gas when charging. 19. Hydro-
gen gas is explosive. Only use the Jump-start System in a well-ventilated area. Do
not allow smoking in the area.
Never exceed the maximum charging time of the Power Pack. 20. Maximum AC
charge time is 48 hours. Maximum DC charge time is 24 hours.
SERVICE
Tool service must be performed only by qualified repair personnel. Service or main-1.
tenance performed by unqualified personnel could result in a risk of injury.
When servicing a tool, use only identical replacement parts. Follow instructions 2.
in the “Inspection, Maintenance, And Cleaning” section of this manual. Use of un-
authorized parts or failure to follow maintenance instructions may create a risk of
electric shock or injury.
UNPACKING
When unpacking, check to make sure that the item is intact and undamaged. If any
parts are missing or broken, please call Harbor Freight Tools at the number shown on the
cover of this manual as soon as possible.
OPERATION INSTRUCTIONS
Note: For additional information regarding the parts listed in the following pages, refer to
the Assembly Diagram near the end of this manual.
Charging the Power Pack
Note: Before initial use, it is necessary to completely charge the Power Pack. Initial
charge time when using an AC outlet is 48 hours. Initial charge time when using a
DC outlet is 24 hours. Always charge on concrete or tile, not on surfaces that are
flammable or surfaces that could get heat damaged.
Press and hold the Battery Status Button (23) on the front of the unit to check the 1.
battery power level: 13 - 15 Volts is ready for use, 12 Volts needs to be charged,
less than 12 Volts should be charged immediately.
Turn the Jump-start Power Switch (18) on the back of the unit to the “OFF” posi-2.
tion.
REV 09e
4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Chicago 96157 - 5 IN 1 PORTABLE POWER PACK wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info