60
· After performing the all-reset procedure, the second hand will remain stopped
even if the crown is returned to the normal position unless the reference position
is set with the crown at both the first and second positions.
· After performing the all-reset procedure, the time shown after setting the refer-
ence position is 12:00 AM. When setting the time manually, set both the time
and date while paying attention to AM and PM so that the time is set correctly.
61
12. Troubleshooting
Problem Check Items Corrective Actions
Unable to receive
radio waves (the
watch cannot be
switched to the receiv-
ing state)
Has button (A) been pressed
until the second hand points to
RX (12:00 position)?
Press button (A) for about 2 seconds,
check that the second hand points to
RX and then try receiving radio
waves again.
Unable to receive
radio waves (even
within the receivable
area)
Are there objects that block
radio waves or generate noise
nearby?
Refer to the sections entitled “For
Good Reception” and “Locations
where Reception may be Difficult”
of this manual. Check if the recep-
tion environment has changed as a
result of rearranging the room and so
forth.
Current time incorrect
even though radio
waves ought to have
been received
Has the reference position of
any of the hands shifted?
Refer to section 10 of this manual
entitled “Setting the Reference Posi-
tion”. If the reference position has
shifted, properly reset the reference
position.
