WIRING AND OPERATION:
1. Connect a jump cable from LNB to satellite finder's "TO LNB" input.
2. Connect the "TO REC" a DC 13-18V power which comes from satellite receiver.
3. Make sure that Satellitefinder is properly connected. Plug in the AC cord and turn
on the satellite receiver. There will have light on the scale, the reading shall be
around 1~2.
4. Make coarse dish alignment by setting Azimuth and Inclination.
5. Set the reading around 5 by adjusting satellite finder's level control on front.
6. Adjust dish position, feedhorn position, and polarization to have the highest
reading on the finder. If full-scale, low down the reading by turning level control
counter clockwise.
7. Remove the jump cable and satellite finder. Resume connection öf satellite
receiver and LNB.
Attention !
When using this unit to install C band dish, you must not place the
satellite finder in front of dish to avoid always full-scale.
When using high gain LNB, gain that higher than 60dB,insert a 5dB attenuator in
between LNB and satellite finder, or replace the jump cable to be a 20ft RG-59U.
SPECIFICATION:
Frequency range : 0.95GHz~ 2.15GHz
Gain : 11dB
Sensitivity : 7 Micro Volts
Power supply : DC13~18V
Operting range : LNB Gain = 52 - 60dB
* : Under the following test condition: LNBgain=55dB,theecarrierC/N = 15dB.
**: Insert a 5dB attenuator when operating with LNB gain = 60~65dB.
Note: all specifications cited in this leatflet are subject to change without notice.