Bedienungsanleitung Clatronic DR 3536 (Seite 27 von 50) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch, Polnisch)

551785

Zoom out

Zoom in

Vorherige Seite

1/50

Nächste Seite

WARNING: Risk of injury!

1. Disconnect the mains plug from the wall socket.

2. Only open the appliance after the pressure has been

released. Press the steam button to do so.

3. If the appliance is still warm, wait approx. 5 minutes until

removing the lid.

4. Press down the lid and turn it anticlockwise to remove.

5. Pour any remaining water from the boiler in order to avoid

overlling.

6. Use the funnel to ll the boiler with a maximum of 600 ml of

water.

7. Attach the lid by turning it clockwise and applying pressure

at the same time.

Installation of accessories

• You have the option of attaching the individual nozzles

directly onto the handle. Insert the accessory onto the

handle until the button (7) clicks into place. To release the

accessory, press the button (7) on the handle.

• The extension pipes enable you to work in large or high ar-

eas. Insert them into each other until the button on the pipe

clicks into place. Attach the pipe to the handle as described

above. To separate the pipes, press the button on the pipe

again.

• If you want to clean sensitive oor surfaces, also attach the

eece cloth to the oor brush.

• For joins, xtures and ttings or hard to reach areas, screw

the round brush onto the jet nozzle attachment.

Electrical Connection

• Before inserting the plug into the socket. Make sure that

the mains voltage to be used matches that of the device.

You can nd this information on the nameplate.

• Connect the device to a duly installed protective contact

socket.

Using the Device

CAUTION:

Before you begin cleaning you should test the materials to

be cleaned as to their suitability for cleaning with steam. Do

not hold the steam nozzle for too long and too close in one

position.

1. To switch on the appliance, set the on/off switch to position I.

2. Pressure starts building up in the boiler after approx.

6 minutes.

3. Press the steam button to generate steam.

NOTE:

• After a long period of non-use, it is normal that a small

amount of condensation, which has formed in the pipe,

will leak out at rst.

• Using the appliance with the maximum water amount

and in continuous operation will allow for steam genera-

tion of up to 15 minutes.

Filling the Water Tank during Operation

No steam will be discharged if the water tank is empty. The

water has to be lled up as follows:

1. To switch off the appliance, set the on/off switch to position

2. Remove the mains plug from the socket!

3. Fill fresh water into the tank as described in the chapter “Fill

in Water” (steps 1-6).

4. Connect the plug to the socket again and switch the appli-

ance on to continue operation.

When you have nished using the device

1. To switch off the appliance, set the on/off switch to position

2. Remove the mains plug from the socket!

3. Let the unit cool down completely.

4. Empty the water tank.

Cleaning

WARNING:

• Always remove the mains plug before cleaning the device.

• Under no circumstances should you immerse the device in water

for cleaning purposes. Otherwise this might result in an electric

shock or re.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Clatronic DR 3536 Seite 27

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info