Bedienungsanleitung Climadiff Clima 19 (Seite 19 von 20) (Englisch, Französisch)

653705

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

TROUBLES

POSSIBLE

CAUSES

SUGGEST

REMEDIES

Unit does

not

Start

when

Pressing

on/off

Button

- P1

appears

in the

display

window

Drain the

water

in the

bottom

tray.

Room temperature

lower

than

the set

temperature.(Cooling

mode)

Reset

the temperature.

Not cool

enough

The windows

doors

the

room

are not

closed.

Make sure

all the

windows

and

doors

are closed.

There

are

heat sources inside

the

room.

Remove

the

heat sources

if possible.

Exhaust

air

duct

is not

connected

blocked.

Connect

the

duct and

make

sure

can function properly.

Temperature setting

is too high.

Decrease

the set temperature.

- Air

filter

blocked

by dust.

Clean

the air filter.

Noisy

or vibration

The ground

is not

level

or not flat

enough.

Place

the

unit

on a

flat,

level

ground

if possible.

Gurgling

sound

The sound comes from

the flowing

of the

refrigerant inside

the

air-conditioner.

It is normal.

Power shut off at

Heating mode

The automatic over

heat

protection function. When

the

temperature

at the air outlet

exceed 70

C/158

F,the

device

wi ll stop.

Switch

again after

the unit

has cool

down.

CARE AND MAINTENANCE

Air filter

(take out)

Fig.24

Air filter

(install)

CARE AND MAINTENANCE

IMPORTANT:

1) Be sure to unplug the unit before cleaning or servicing.

2) Do not use gasoline, thinner or other chemicals to clean

the unit.

3) Do not wash the unit directly under a tap or using a hose.

It may cause electrical danger.

4) If the damaged power supply cord must be replaced with

a new power supply cord obtained from the product

manufacturer

and not repaired.

1. Air filter

- Clean the air filter at least once every two weeks to prevent

inferior fan operation because of dust.

- Removal

Take the air filter out along the arrow direction (Fig.24).

- Cleaning

Wash the air filter by immersing it gently in warm water

(about 40

C/104

F) with a neutral detergent. Rinse the filter

and dry it in a shady place.

- Mounting

Install the air filter after cleaning (see Fig.25).

TROUBLE

SHOOTING

TROUBLESHOOTING

TIPS

Fig.25

NOTE:

The grill and the air filter are connected and can be

separated.

2. Unit enclosure

- Use a lint-free cloth soaked with neutral detergent to clean

the unit enclosure. Finished by a dry clean cloth.

3. Unit idle for a long time

- Remove the rubber plug at the back of the unit and attach

a hose to drain outlet

Place

the

open

end of the hose

directly

over the

drain area

in your

basement

floor

(See Fig.22 & 23).

- Remove the plug from the bottom drain outlet, all the water

in the bottom tray would drain out (See Fig.24).

- Keep the appliance running on FAN mode for half a day in

a warm room to dry the appliance inside and prevent mold

forming.

- Stop the appliance and unplug it, wrapped the cord and

bundle it with the tape. Remove the batteries from

the remote

controller.

- Clean the air filter and reinstall it.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Climadiff Clima 19 Seite 19

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info