Bedienungsanleitung Cobra MR HH325 VP (Seite 33 von 35) (Englisch)

521977

Zoom out

Zoom in

Vorherige Seite

1/35

Nächste Seite

Intro Operation Customer

ssistance

Warranty

Notice

Main Icons

econdary Icons

Caution Warning

Installation

Customer

Assistance

IInnttrroodduuccttiioonn

5599NNootthhiinngg

Com

es Close to a Cobra

MMaaiinntteennaannccee aanndd

TTrroouubblleesshhoooottiinngg

No display on LCD when

radio is turned On

Batteries are exhausted

Batteries not installed

properly

Recharge or

replace batteries

Remove batteries and

reinstall according to

polarity markings

NiMH batteries run

down quickly

Batteries are at the

end of their life

Replace with new

batteries

Will transmit at

one (1) or three (3) watts,

but not at five (5) watts

Batteries are low

Selected channel is imited

to one (1) watt

Recharge or

replace batteries

Switch to

another channel

Will not transmit Selected channel is

limited to receive only

Switch to

another channel

No sound from speaker Volume level is too low or

squelch level is too deep

Re-adjust volume

and squelch

No response to

button press

Button lock is On Press Backlight/

Key Lock button

No answer to calls Out of range of

other station

Signal is blocked

by terrain

Switch to three (3) or five

(5) watts or move closer

Move until you have a “line-

of-sight” to the other station

Problem Possible Cause(s) Solution(s)

ntro Operation Customer

ssistance

arranty

Notice

Main Icons

Secondary Icons

Caution Warning

nstallation

ustomer

Assistance

Operating Your Radio

Maintenance

•

Very little maintenance is required to keep your CobraMarine VHF radio

in good operating condition:

■

Keep the radio and charger clean by wiping with a soft cloth and mild detergent.

Do not use solvents or harsh or abrasive cleaners, which could damage the

case or scratch the LCD screen.

■

If the radio is exposed to salt water, wipe with a soft, moist cloth at least once a day to

prevent buildup of salt deposits, which could interfere with button operation.

■

If the radio will be stored for a long period, such as over the winter,

remove the batteries from the battery tray and store them in a separate

package. This is especially important if you are using alkaline batteries.

Troubleshooting

•

5588

EEnngglliisshh

PPrroodduucctt FFeeaattuurreess

To Enter Memory Location Scan:

1. From Marine Standby mode, press the MEM/ESC

button.

2. Press the SCAN button. The radio will immediately

begin to scan all pre-assigned memory channels.

The SCAN and MEM icons will show on the LCD.

3. A signal on any channel will stop the scan for 10

seconds to allow you to listen to the traffic on that

location.

4. Press the Channel Up/Down button to resume

scanning the Memory Location Scan channels or to

change the scan direction.

5. To EXIT Memory Location Scan mode, press the

SCAN button again. The SCAN and MEM icons will

disappear from the LCD and the radio will return to

Marine Standby mode.

MEM/ESC Button

SCAN Button

ntro Operation Customer

ssistance

arranty

Notice

Main Icons

Secondary Icons

Caution Warning

nstallation

ustomer

Assistance

Operating Your Radio

www.busse-yachtshop.de | info@busse-yachtshop.de

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Cobra MR HH325 VP Seite 33

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Cobra MR HH325 VP

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info