652347
52
Zoom out
Zoom in
Vorherige Seite
1/56
Nächste Seite
52
6.6.5 Resetting fault indication (red LED lit)
In order to return the steam humidifier to operation after fault elimination (Error), the steam humidifier
must be switched off for approx. 5 seconds and then switched on again.
Note: Resetting maintenance indication see chapter 6.5.5.
6.6.3 Instructions for fault elimination
When eliminating faults, the steam humidifier must be taken out of operation (see
chapter 6.4).
Warning danger of death! Take care that the electricity supply to the main
contactor is cut off (test with voltage tester).
Repair work and replacement of faulty components may only be carried out by
your Condair representatives service technician or personnel authorized to do
the work!
Warning! Malfunctions relating to the electrical installation must only be
repaired by authorized personnel.
Electrical components are very sensitive to electrostatic discharge. Measures must
be taken to protect these components against electrostatic discharge during all repair
work (ESD protection).
Only use original spare parts from your Condair supplier for the replacement of faulty
components.
Warning: Danger of death! Before changing the unit fuse, the steam humidifier must be
switched off and secured against unintentional reconnection as described in chapter 6.4.
Take care that the electricity supply to the main contactor is disconnected (check with voltage
tester).
Important! If the fine-wire fuse on the control print blows this is usually due to a faulty coil of the inlet
or drain valve or the main contactor. Therefore you should test these components before replacing the
fuse.
Only use fuses of the given type with the specified nominal current strength to
replace the fuse
Warning! It is not permitted to use repaired fuses or to short-circuit the fuse holder.
6.6.4 Replacement of fine-wire fuse on the control print
models N4/H4
all other models
52

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Condair CP2 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info