Bedienungsanleitung Corbero CLSV961420T (Seite 32 von 36) (Englisch)

751453

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

EN - 29

11. TROUBLESHOOTING





below, then you should:

 

 Turn off the water supply.

 

FAULT  

Your machine will not start.

It is not plugged in. Insert the plug into the socket.

The fuse is faulty. Replace the fuse.

Mains supply is cut off. Check the mains supply.

Start/Pause button is not pressed. Press the Start/Pause button.

The programme dial is in the Stop

(off) position. Turn the program dial to the desired position.

The door of your machine is not

closed properly. Close the door of your machine.

Your machine does not

discharge

Drain hose is clogged or twisted. Check the drain hose.

Pump filter clogged. Clean the pump filter.

Your machine vibrates.

The feet have not been adjusted. Adjust the feet.

Transit bolts have not been

removed. Remove the transit bolts from your machine

Your machine only has a small

amount of laundry inside.

This will not prevent the operation of your

machine.

Your machine is overloaded with

laundry or the laundry is not

distributed evenly.

Do not overload your machine. Make sure the

laundry is spread out.

Your machine is located on a hard

surface.

Avoid installing your machine on a hard surface.

When installing your machine, leave a

2 cm gap between walls or hard surfaces.



the detergent drawer.

Too much detergent has been

used

Press the Start/Pause button. To stop the foam,

dilute one tablespoon of softener into 1/2 litre of

water and pour into the detergent drawer. Press

the Start/Pause button after 5-10 mins

Wrong detergent used. Use detergents produced only for automatic

washing machines in your machine.



result.

The laundry is too dirty for the

programme you have selected.

Select programmes appropriate for your laundry’s

level of dirtiness. (See page 21 programme table)

Not enough detergent used. Use the amount of detergent as instructed on the

packaging

There is too much laundry in your

machine.

Check that the maximum capacity of your

Washer Dryer is not exceeded.

As soon as the machine is

loaded with water, water

discharges.

The end of the water drain hose is

too low for the machine. Set the water drain hose to an appropriate height.

No water appears in the

drum during washing.

No fault. Water is in the unseen

part of the drum. - .

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Corbero CLSV961420T Seite 32

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Corbero CLSV961420T

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info