Bedienungsanleitung Corbero CLVG6048X (Seite 36 von 42) (Englisch, Spanisch)

751434

Zoom out

Zoom in

Vorherige Seite

1/42

Nächste Seite

Intensive

Crystal

Rapid

Programme)

(Standard

WARNING!

- Capacity: 12 settings

- Position of upper basket: Low position

- Rinse aid setting: 5 (or 4 for four setting dispenser)

6. Starting a Washing Programme

Wash cycle table

Program

Cycle Selection

Information

Description

of Cycle

Detergent

Pre/main

Running

Time(min)

Energy

(kWh)

Water

(L)

For the heaviest soiled loads,

such as pots, pans, casserole

dishes and dishes that have

been sitting with dried food

on them for a while.

For normally soiled loads,

such as pots, plates, glasses

and lightly soiled pans.

standard daily cycle.

For lightly soiled loads, such

as plates, glasses, bowls and

lightly soiled pans.

Light wash cycle to be used

for more delicate items which

are sensitive to high

temperatures.(Run cycle

immediately after use)

A shorter wash for lightly

soiled loads that do not

need drying.

To rinse dishes that you

plan to wash later that day

Pre-wash

Main wash(60℃)

Rinse1

Rinse2

Hot rinse

Drying

Pre-wash

Main wash(46℃)

Hot rinse

Drying

Pre-wash

Main wash(45℃)

Rinse

Hot rinse

Drying

Main wash(40℃)

Rinse

Hot rinse

Drying

Main wash(40℃)

Hot rinse

Pre-wash

4/16

3/15

180

237

137

124

1.30

0.922

0.85

0.80

0.50

0.01

Starting a wash cycle...

Draw out the lower and upper basket, load the dishes and

1. push them back. It is recommended to load the lower basket first, then the upper one (see the

section entitled "Loading the Dishwasher"). Pour in the detergent (see the section entitled "Salt,

Detergent and Rinse Aid").

2. Insert the plug into the socket. The power supply is 220-240V AC 50 Hz, the specification of the

Turning on the Appliance

Light

Pre-Rinse

Eco

(*E 60436)

It is dangerous to open the door when washing, because the hot water may scald you.

Switch Off the Dishwasher

The digital display appears "--" and the buzzer rings 6 times, only in this case the programme

has ended.

1.Switch off the dishwasher by pressing the ON/OFF button.

2.Turn off the water tap!

Open the door carefully. Hot steam may escape when the door is opened!

■Hot dishes are sensitive to knocks. The dishes should therefore be allowed to cool down around

15 minutes before removing from the appliance.

■Open the dishwasher's door, leave it ajar and wait a few minutes before removing the dishes. In

this way they will be cooler and the drying will be improved.

Unloading the dishwasher

It is normal that the dishwasher is wet inside.

Empty the lower basket first and then the upper one. This will avoid water dripping from the upper

basket onto the dishes in the lower one.

Switching on

1. Open the tap, if it is closed.

2. Close the door.

3. Make sure the spray arms are not obstructed.

4. Switch the dishwasher on using the ON/OFF button.

Select a programme

Choose your programme according to the type of load and how dirty it is.

The different programmes and their uses are described in the programme chart later on in this

booklet. Use the programme selector to select the expected programme .

Change the Programme.

Premise: A cycle that is underway can only be modified if it has only been running for a short time.

Otherwise, the detergent may have already been released, and the appliance may have already

drained the wash water. If this is the case, the detergent dispenser must be refilled (see the section

entitled " Fill in the Detergent " ).

1:Press the " ON/OFF" button or " Reset" button 3 seconds(dishwasher with " reset" button) to cancel

the programme.

2: Turn on it again. Then rotate the programme selector to the expected cycle setting (see the section

entitled "Starting a wash cycle. . . " ).

NOTE: If you open the door when the washing cycle underway, the appliance will pause and emit

warning signals, the digital display show " E1" and flash. When you close the door, the machine will

keep on working after 10 seconds.

Forget to Add Dish

A forgotten dish can be added any time before the detergent cup opens.

1 Open the door a little to stop the washing.

2 After the spray arms stop working, you can open the door completely.

3 Add forgotten dishes.

4 Close the door, the dishwasher will work after ten seconds.

Cycle Table".)

With a little force to ensure the door is properly closed.

NOTE: A click could be heard when the door is closed perfectly.

When the washing is over, you can shut off the switch by pressing ON/OFF button.

socket is 12 A 250 VAC.50 Hz.

Make sure that the water supply is turned on to full pressure. Open the door, press the ON/OFF

button, Press the "program." button to select a desired "Wash cycle". (See the section entitled "Wash

EN 60436: this program is the test cycle

The information for comparability test in accordance with EN60436, as follows:

1.The ECO program is suitable to clean normally soiled tableware,it is the most efficent program in

terms of its combined energy and water consumption

2 Manual pre-rinsing of tableware items leads to increased water and energy consumption and is not

recommended .water and energy consumption and is not recommended .

3 Washing tableware in a household dishwasher usually consumes less energy and water than hand

dishwashing when the household dishwasher is used according to this instruction manual.

Corbero CLVG6048X Seite 36

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info