Bedienungsanleitung Cressi Archimede I (Seite 5 von 33) (Englisch)

618068

Zoom out

Zoom in

Vorherige Seite

1/33

Nächste Seite

fatigue, and dehydration. All these conditions and all those

that can jeopardize your safety should be avoided.

IMPORTANT:

this device should be used by certified

divers only. No dive computer can actually replace proper

training. Do remember that dive safety can be ensured by

proper training only.

IMPORTANT: The Archimede Cressi-sub dive computer

has been designed for recreational diving and not for pro-

fessional applications requiring prolonged immersion time

with subsequently increased DCS risk.

IMPORTANT: check your dive computer before use, by

checking battery power and that all LCD segments are

properly displayed. DO NOT dive, if the dive computer

instructions are unclear and, above all, if the low battery

icon is displayed.

IMPORTANT: for your dive, you also need a depth

gauge, a pressure gauge, a timer or a clock, and decom-

pression tables. Always check that the cylinder pressure is

appropriate for the planned dive and, during the dive, use

the pressure gauge to regularly check the amount of air

remaining in your cylinders.

 DANGER: Never start your altitude dive, before the

dive computer has automatically set the proper program

for altitude calculation. Check the altitude level on the dis-

play. Remember that in case of dives at more than 9843 ft

above sea level, the risk of DCS is significantly higher.

 DANGER: Before any flight travel, wait for the “No Fly

Time” Icon to disappear from the dive computer display.

IMPORTANT: The use of this dive computer is strictly per-

sonal. The information it provides exclusively refers to the

diver who has used it during the single or repetitive dives.



DANGER:

Cressi-sub advises you against using this

dive computer for decompression dives. However, should

you exceed the safety curve limits, Archimede Cressi-

Sub dive computer can supply you with all the information

you need for decompression, ascent, as well as proper

surface interval time

 DANGER: Never dive with a Nitrox cylinder without

having personally checked its content and the proper O2

percentage. You should then input this value in the com-

puter. Remember that the dive computer does not accept

FO2 decimal figures. Always round down the figure

(example 35.8% must be rounded down to 35%).

 DANGER: for safety reasons, in your Archimede dive

computer, PO2 default value is set at 1.4 bar also for dives

with air. If you need to further raise the safety margin, PO2

can be set at lower values, down to 1.0 bar, with 0.1bar

decreases at a time.

 DANGER: : avoid all high risk profile dives, such as the

so called “yo-yo” dives, reversed profile dives, or repetitive

dives in the same day or in consecutive days. They are

potentially risky and involve a high risk of DCS!

IMPORTANT: Turn on the safety factor whenever you

realize that there are factors likely to increase your DCS

risk. You will thus perform a more conservative dive.

NOTE: When flying, it is recommended to keep the dive

computer with you in the pressurized cabin.

ENGLISH

131

ARCHIMEDE 1 27-09-2005 16:17 Pagina 131

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Cressi Archimede I Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info