634197
37
Zoom out
Zoom in
Vorherige Seite
1/40
Nächste Seite
38
If you have any implants such as a pacemaker, you mustn’t use the
chest strap-pulse monitor. Its radio signal could potentially interfere with
your implant. In this case, pulse-controlled training programmes may not
be used.
Danger to your health due to overexertion when
training! Incorrect or excessive training can damage your health.
Intensity
Intensive fitness training involves the whole body, not only the lower leg
muscles. The body, particularly the heart and circulation, requires time to
adapt to the changes resulting from training. It is therefore important to
increase the intensity slowly and be sure to allow appropriate rest before
and after training. Thus train at an intensity level at which you do not
become overexerted. Listen to your body: end the training immediately if
you feel unwell are short of breath of feel dizzy during training. If you are
training properly you can still have a normal conversation during training.
Do not forget to adjust your bike to your body: having the seat too high
or too low can lead to undue stress.
Warm up/cool down
Cooling down is just as important as a proper warm-up programme.
End you training gradually: reduce the speed and stress level and
perform light stretching exercises after you exit the equipment. This allows
your pulse to slowly recover and your body can better regenerate for
further stress.
The duration of the cool-down phases between training units should be
based on your fitness levels.
Avoid an intensity level that is too high to prevent ex-
cessive training. Overexertion can cause health problems and lead
to death. If you have feelings of fatigue or weakness you must stop the
training immediately.
You can determine your individual training intensity using the following
calculation of your maximum heart rate (MHR):
MHR = 220 – your age
Depending on the purpose of the training, there are 5 training zones
within which you can train based on your maximum heart rate.
Zones
Cool down zone = 50-60% of MHF
Fat burning zone = 60-70% of MHF
Carbohydrate burning zone = 70-80% of MHF
Anaerobic zone = 80-90% of MHF
Red line zone = 90-100% of MHF
Cool down zone
This training is geared towards basic fitness. It consists of extended
endurance activities to be performed slowly. It is particularly suited for
beginners and/or physically weak people.
Fat burning zone
The training is used to strengthen the cardio-vascular systems and is
optimised for fat burning. In this scenario, the body burns proportionally
more kilojoules of fat. During training you should feel relaxed and be
able to converse.
Carbohydrate burning zone
Here the body burns more carbohydrates than fat. The training is more
strenuous but more effective.
Anaerobic zone
In the anaerobic zone the body cannot meet the oxygen demand of the
body. Training in this zone is very demanding and energy-sapping.
Performance athletes briefly train in this zone to reach a maximum
increase in performance. Sports enthusiasts who train for the sake of their
health should avoid this zone
Red line zone
This zone is for high performance athletes. Due to the extreme intensity
the heart rate approaches the maximum level. The danger of injuries and
health damages are high.
Stretching
Stretching chest muscles (Fig. 12)
Place your elbow and forearm against the wall, upper arm and forearm
forming a right angle. Now turn the upper body slightly away from the
arm. Switch side every 20-30 seconds. This exercise works the chest
muscles and the deltoid.
Stretching neck muscles (Fig. 13)
Stand and tilt your head towards your shoulder. The other shoulder simul-
taneously moves towards the ground. You should feel this exercise at the
side of your neck. Switch sides every 20-30 seconds. This exercise works
the trapezius (descending portion).
12
13
GB
37

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

crivit-ian-74884---ergometer-bike

Suche zurücksetzen

  • Handkontaktsensoren ungenaue Anzeige; angezeigte Pulswerte steigen zu schnell Eingereicht am 16-5-2022 18:52

    Antworten Frage melden
  • Gerät erzeugt beim Treten Geräusche . Ich möchte der Ursache auf den Grund gehen und die Verkleidung des Antriebs entfernen .Die Schrauben konnte ich natürlich entfernen. Jetzt geht es leider nicht weiter . Befürchte die Kunststoffteile zu beschädigen. Ich bitte um Hilfe. Eingereicht am 23-2-2017 19:27

    Antworten Frage melden

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Crivit IAN 74884 - Ergometer Bike wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info