Technical Specifications: Crosley C10
Nominal Speeds 33
1/3
& 45RPM
Speed Variance ±0.8 %
Wow and Flutter ±0.12 %
Signal to Noise -65dB
Downforce Range 10 - 30mN
Effective Tonearm Length 8.6 “ ( 218.5mm)
Overhang 0.73in
Power Consumption 2W
Outboard Power Supply 16V/500mA AC
Dimensions (W x H x D) 16.34in x 4.65in x 12.60in, with lid open 16.34in x 14.37in x 16in
Weight 12.13lbs
Technical specifications: NP8 (ORTOFON OM 5E)
Frequency response 20Hz - 20kHz Recommended load resistance 47kohms
Channel balance <2dB Amplifier connection MM -input
Channel separation >22dB Recommended tracking force 17.5mN
Output voltage 4mV Weight 0.18 oz.
Potential Incorrect Use and Fault Conditions
Crosley turntables are manufactured to the highest standards and undergo strict quality controls before leaving the
factory. Faults that may possibly occur are not necessarily due to material or production faults but can sometimes be
caused by incorrect use or unfortunate circumstances. Therefore the following list of common fault symptoms is included.
The platter doesn’t turn although the unit is switched on:
- The unit is not connected to the main power supply.
- No power at the outlet.
- Drive belt is not installed or has slipped off.
No signal through one or other channel or both channels:
- Phono input not selected at amplifier.
- Amplifier not switched on.
- Amplifier or speakers muted.
- No connection to the speakers.
- No connection between turntable and amplifier.
- Wire leads not connected the cartridge.
Strong hum on phono input:
- No ground connection from cartridge, arm, or arm cable to amplifier or ground loop.
- Turntable too close to speakers.
Distorted or inconsistent sound from one or both channels:
- Turntable is connected to wrong input of amplifier.
- Needle or cantilever damaged.
- Belt is on wrong RPM groove.
- Drive belt overstretched or dirty.
- Platter bearing without oil, dirty or damaged.
- Dust on stylus.
- MM/MC switch on preamplifier set incorrectly.
