498270
11
Zoom out
Zoom in
Vorherige Seite
1/12
Nächste Seite
11
ENG
POWER SUPPLY AND TURN ON CONNECTION (FIG. 2)
(1) GND terminal for the ground
(2) REMOTE terminal for the turn on connection
(3) +12 V terminal for the positive-connection of the battery
(4) Vehicle’s battery
(5) In-Line Fuse 50 A ANL (not included in the scope of delivery and required)
(6) Turn on wire from the headunit or the electrical antenna
1-CHANNEL MONO OPERATION STEREO (FIG. 3) WITH 1 SUBWOOFER
If you want to run the amplifier with the 2 line output channels from the headunit to drive 1 subwoofer,
connect the following setup:
(1) To the headunit, line output left
(2) To the headunit, line output right
(3) Subwoofer (1-8 Ohms)
(4) Bass remote control to adjust the bass level out of the driver’s seat
FIGURES (P. 28-30)
This LED (Fig. 1, 1) lits up in green, if the amplifier is in operation. If this LED lits up in red, the amplifier
is overheated, or a short circuit occurs resp. a too low impedance load is connected to the speaker
outputs. If this events, the internal built-in protection circuit shuts down the amplifier automatically. The
amplifier should work again properly after you have solved the problems.
PROTECTION CIRCUIT
CONNECTIONS AND CONTROLLERS (FIG. 1)
(1) Power-/Protection-LED
(2a) Mono audio input (LINE INPUT), coming from an additional GPX2000.1D
(2b) Mono audio input (OUT), leading to an additional GPX2000.1D
(3) Stereo audio input, coming from the headunit
(4) Remote jack for the included bass remote control
(5) Gain level controller
(6) Lowpass filter controller
(7) Subsonic filter controller
(8) Bass Boost frequency controller
(9) Bass Boost controller
1-CHANNEL MONO OPERATION STEREO (FIG. 4) WITH 2 SUBWOOFERS
If you want to run the amplifier with the 2 line output channels from the headunit to drive 2 subwoofers,
connect the following setup:
(1) To the headunit, line output left
(2) To the headunit, line output right
(3) Subwoofer 1 (2-8 Ohms)
(4) Subwoofer 2 (2-8 Ohms)
(5) Bass remote control to adjust the bass level out of the driver’s seat
11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Crunch GPX 2000.1D wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info