657565
34
Zoom out
Zoom in
Vorherige Seite
1/37
Nächste Seite
| 63 62 |
MTB/ ROAD BIKE/ TREKKINGMTB/ ROAD BIKE/ TREKKING
There is no lever on the brake:
Follow the reverse procedure to opening
and press the pin on the brake lever from
outwards to inwards.
At the same time, pull the brake lever.
4. Check installation:
Operate the brakes.
If the brake block or brake touches the rim
or the brake disks, this can indicate that the
hub has not been correctly seated in the
dropouts.
In that case release the quick release, check
and correct the hub seat and close the quick
release again.
The brake (on rim brakes) must not be
opened during this procedure. If there is no
improvement after this, please contact your
dealer immediately.
11.2 Remove and replace seat post
and saddle
Risk of Personal Injury and
Material Damage!
An incorrectly tted saddle post can lead
to dangerous riding situations, falling,
accidents and material damage.
You must have your dealer demonstrate
tting and removing your saddle post.
Practise this job at least once under his
supervision and control.
Only remove and t the saddle post and
saddle if you are sure you have mastered
this job.
For transportation, you can remove your bike‘s
saddle post complete with saddle and replace it
again afterwards.
The saddle post is held with a clamp in the frame se-
at tube and is tightened with either a quick release
or a hexagon socket.
On carbon bre saddle posts, special types may be
tted with two screws.
For clamping without a quick release, a hexagon
socket and a torque wrench of the appropriate size
are required. Please also consult your dealer.
To remove your saddle post:
1. Release the saddle clamp at the quick
release as per Chapter 8.8 or by loosening
the Allen screw with an Allen key.
2. Withdraw the saddle with saddle post
from the frame.
To replace your saddle post:
placing the rear wheel under it so that the
chain is over the smallest sprocket
Carefully lower the rear of the bike until the
axle is at the dropout stop on the right and
left sides.
b) To assemble the front wheel
Lift up the bike by the handlebars,
placing the front wheel under the front forks
dropouts and
carefully lower the forks until the axle is ush
at the dropout stops on the right and left
sides.
2. Tighten the wheel hubs.
When tightening with quick releases: see
Chapter 8.8
3. Close rim brakes
a) On racing bike brakes:
Shimano und Sram:
Move the lever downwards.
b) Campagnolo:
34

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

cube-trekking

Suche zurücksetzen

  • Wie schalte ich das Licht über das Display ein? Wo schalte ich ein und aus? Eingereicht am 30-5-2021 14:25

    Antworten Frage melden

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Cube Trekking wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Cube Trekking

Cube Trekking Bedienungsanleitung - Deutsch - 75 seiten

Cube Trekking Bedienungsanleitung - Holländisch - 37 seiten

Cube Trekking Bedienungsanleitung - Französisch - 37 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info