Bedienungsanleitung Daikin AHQ125CV1 (Seite 4 von 124) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch)

688988

Zoom out

Zoom in

Vorherige Seite

1/124

Nächste Seite

1-2

SAFETY PRECAUTIONS

! WARNING ! CAUTION

Installation and maintenance should be performed by qualified

persons who are familiar with local code and regulation, and

experienced with this type of appliance.

All field wiring must be installed in accordance with the national

wiring regulation.

Ensure that the rated voltage of the unit corresponds to that of

the name plate before commencing wiring work according to

the wiring diagram.

The unit must be GROUNDED to prevent possible hazard due

to insulation failure.

All electrical wiring must not touch the refrigerant piping, or

any moving parts of the fan motors.

Confirm that the unit has been switched OFF before installing

or servicing the unit.

Disconnect from the main power supply before servicing the

air conditioner unit.

DO NOT pull out the power cord when the power is ON. This

may cause serious electrical shocks which may result in fire

hazards.

Keep the indoor and outdoor units, power cable and transmission

wiring, at least 1m from TVs and radios, to prevent distorted

pictures and static. {Depending on the type and source of the

electrical waves, static may be heard even when more than 1m

away}.

•

Please take note of the following important points when installing.

Do not install the unit where leakage of flammable gas may occur.

If gas leaks and accumulates around the unit, it may cause

fire ignition.

Ensure that drainage piping is connected properly.

If the drainage piping is not connected properly, it may

cause water leakage which will dampen the furniture.

Do not overcharge the unit.

This unit is factory pre-charged.

Overcharge will cause over-current or damage to the

compressor.

Ensure that the unit’s panel is closed after service or

installation.

Unsecured panels will cause the unit to operate noisily.

Sharp edges and coil surfaces are potential locations which

may cause injury hazards.

Avoid from being in contact with these places.

Before turning off the power supply, set the remote

controller’s ON/OFF switch to the “OFF” position to prevent

the nuisance tripping of the unit. If this is not done, the unit’s

fans will start turning automatically when power resumes, posing

a hazard to service personnel or the user.

Do not operate any heating apparatus too close to the air

conditioner unit. This may cause the plastic panel to melt or

deform as a result of the excessive heat.

Do not install the units at or near doorway.

Do not operate any heating apparatus too close to the air

conditioner unit or use in room where mineral oil, oil vapour

or oil steam exist, this may cause plastic part to melt or

deform as a result of excessive heat or chemical reaction.

When the unit is used in kitchen, keep flour away from going

into suction of the unit.

This unit is not suitable for factory used where cutting oil

mist or iron powder exist or voltage fluctuates greatly.

Do not install the units at area like hot spring or oil refinery

plant where sulphide gas exists.

Ensure the color of wires of the outdoor unit and the terminal

markings are same to the indoors

respectively.

IMPORTANT: DO NOT INSTALL OR USE THE AIR

CONDITIONER UNIT IN A LAUNDRY ROOM.

Don’t use joined and twisted wires for incoming power supply.

Avoid direct contact of any coil treatment cleaners on plastic part. This

may cause plastic part to deform as a result of chemical reaction.

For any enquiries on spare parts please contact your

authorized dealer.

The equipment is not intended for use in a potentially

explosive atmosphere.

•

This manual provides the procedures of installation to ensure a safe and good standard of operation for the air conditioner unit.

Special adjustment may be necessary to suit local requirements.

Before using your air conditioner, please read this instruction manual carefully and keep it for future reference.

This appliance is intended to be used by expert or trained users in shops, in light industry and on farms, or for commercial use by lay persons.

This appliance is not intended for use by persons, including children, with reduced physical, sensory or mental capabilities, or lack of experience

and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.

Children should be supervised to ensure that they do not play with the appliance.

INSTALLATION MANUAL

NOTICE

Disposal requirements

Your air conditioning product is marked with this symbol. This means that electrical and electronic products shall not be mixed with unsorted

household waste.

Do not try to dismantle the system yourself: the dismantling of the air conditioning system, treatment of the refrigerant, of oil and of other

parts must be done by a qualified installer in accordance with relevant local and national legislation.

Air conditioners must be treated at a specialized treatment facility for re-use, recycling and recovery. By ensuring this product is disposed

of correctly, you will help to prevent potential negative consequences for the environment and human health. Please contact the installer or

local authority for more information.

Batteries must be removed from the remote controller and disposed of separately in accordance with relevant local and national legislation.

1 IM 5CEY-0711(5)SIESTA-EN.indd 21 IM 5CEY-0711(5)SIESTA-EN.indd 2 10/12/17 9:46:45 AM10/12/17 9:46:45 AM

Daikin AHQ125CV1 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info