585987
17
Zoom out
Zoom in
Vorherige Seite
1/20
Nächste Seite
Rhino™ 10 Installation Manual
Connecting a Scanner
Connecting a Tethered Scanner
You can attach a tethered scanner to one of the serial or USB ports on the Rhino™ 10. Be sure to order your scanner
with the appropriate cable.
USB Scanner
1. Loosen the screws on the USB retainer and move the retainer away from the USB connector.
2. Plug the cable into one of the USB ports. Depending on the scanner you are attaching, you may hear a series
of beeps and the Good Read light may flash.
3. Slide the USB retainer toward the connector until it is firmly against the USB connector. Tighten the two
screws.
Figure 13 – USB Retainer Clip
Serial Scanner
1. The serial ports can supply either 5V or 12V power on pin 9 of the connector. The factory default is 5V
on COM1 and COM2. Verify which voltage the scanner requires.
2. If necessary, attach the cable to the tethered scanner.
3. Attach the scanner RS-232 cable to one of the COM connectors on the Rhino™ 10. Depending on the
scanner you are attaching, you may hear a series of beeps and the Good Read light may flash. Tighten
the screws to make sure the cable stays attached during use.
4. See the Users guide to configure the serial ports to work with the scanner.
Changing Serial Port Voltage
You can change the voltage available on the serial ports to supply no power, +5 VDC, or +12 VDC up to a maximum of
one amp total. The voltage selection jumpers are located under the top right cover.
This operation requires an ESD protected workstation!
Failure to pre
vent ESD damage may void the warranty. If in doubt, have an authorized Datalogic Partner
perform this installation for you.
To change the serial port voltage
13
17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Datalogic Rhino 10 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Datalogic Rhino 10

Datalogic Rhino 10 Bedienungsanleitung - Englisch - 40 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info