Back to Contents Page
Camera Module
Dell™XPS™L511zServiceManual
Removing the Camera Module
Replacing the Camera Module
Removing the Camera Module
1. Follow the instructions in Before You Begin.
2. Remove the base cover (see Removing the Base Cover).
3. Remove the battery (see Removing the Battery).
4. Follow the instructions from step 5 to step 16 in Removing the System Board.
5. Remove the display assembly (see Removing the Display Assembly).
6. Remove the display bezel (see Removing the Display Bezel).
7. Remove the display panel (see Removing the Display Panel).
8. Disconnect the camera cable from the connector on the camera module.
9. Carefully lift the camera module off the display back cover.
Replacing the Camera Module
1. Follow the instructions in Before You Begin.
2. Connect the camera cable to the connector on the camera module.
3. Use the alignment posts to place the camera module on the display back cover.
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: Onlyacertifiedservicetechnicianshouldperformrepairsonyourcomputer.DamageduetoservicingthatisnotauthorizedbyDell™
is not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
