Bedienungsanleitung DeLonghi PAC C100E (Seite 6 von 15) (Englisch)

616285

Zoom out

Zoom in

Vorherige Seite

1/15

Nächste Seite

INTRODUCTION

Thank you for choosing a De’Longhi product. Please take a few

moments to read the instructions to avoid risks or damage to the

appliance.

DESCRIPTION

1 air outlet grille

2 control panel

3 castor wheels

4 handles

5 lter

6 air intake grille

7 air exhaust hose housing

8 drainage hose with cap

9 power cable

10 wall ange

11 air exhaust hose

12 window outlet

13 castor locks

14 remote control

15 window bracket with locking pins

16 window bracket extension

To avoid damage to the unit

NEVER TRANSPORT OR TURN THE APPLIANCE UPSIDE DOWN OR

ON ITS SIDE. IF THIS OCCURS, WAIT 6 HOURS BEFORE TURNING

THE APPLIANCE ON, 24 HOURS IS RECOMMENDED. After the unit

has been on its side, oil needs to return to the compressor to

ensure proper function. Without allowing the unit this time (6-

24 hours) the unit may function for only a short time, and then

the compressor will break down from lack of oil.

Electrical connection

Before plugging the appliance into the outlet, check that:

• The outlet’s power supply corresponds to the value

indicated on the rating label on the back of the appliance;

• The outlet and electrical circuit are adequate for the

appliance;

• Theoutletisa3-holegroundedoutlet . If this is not

the case, you must choose another outlet. Failure to

follow these important safety instructions absolves the

manufacturer of all liability.

it becomes necessary, the power cable must be replaced

by a qualied professional only.

The instructions below will enable you to prepare your air

conditioner for operation as eciently as possible. Before use,

make sure the air intake and outlet grilles are unobstructed.

USE

AIR CONDITIONING WITHOUT INSTALLATION

For optimal results set-up in a double-hung window:

1) Place the bracket in the window sill, extend the bracket

fully within the window frame, x the bracket by using the

pin then lower the window onto the bracket. (Should the

window bracket be too large for the window. The plastic

can be cut with a saw by a qualied professional.)

2) Fit the air exhaust hose in the housing at the back of the

appliance. Insert it as shown in gure A.

3) Connect the window outlet (12) to the other end of the

exhaust hose.

4) Insert the window outlet end of the exhaust hose into the

slot of the window bracket (g. B).

Other set-up methods:

• Thankstothelockingpins,it’spossibletousethewindow

bracket also for sliding windows. Position the hole of the

bracket so to allow a correct installation of the exhaust hose

(see gure C).

• Ifyouhaveacasementwindow(gureD)followsteps2&

3 and place the window outlet (12) outside the window to

exhaust the hot air.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

DeLonghi PAC C100E Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info