en
Using the remote control unit (some models only)
MODELS WITH REMOTE CONTROL
control at the
receiver on the air
remote control
must be no more
than 16,4 ft (5 metres) away from the appliance (without
obstacles between the remote control and the receiver).
Do not drop it or expose it to direct sunlight or sources of
heat.
DESCRIPTION OF THE REMOTE CONTROL
19) “ON/OFF” button
20) Increase /Decrease button for temperature/programmed
use
21) “MODE” button
22) “TIMER” button
23
24) Fan speed selection button (MAX/MED/MIN).
Inserting or replacing the batteries
instructions inside the battery compartment);
If the remote control unit is replaced or discarded, the
batteries must be removed and disposed of in accordance
with current legislation as they are harmful to the
environment. Do not mix old and new batteries. Do not
mix alkaline, standard (carbon-zinc) or rechargeable
(nickel-cadmium) batteries. Do not dispose of batteries
in re. Batteries may explode or leak. If the remote
control will not be used for a certain length of time,
remove the batteries.
Note:
reasonable protection against harmful interference in a
residential installation.
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment o and on, the user
is encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and
receiver.
- Connect the equipment into an outlet on a circuit
dierent from that to which the receiver is connected.
technician for help. Changes or modications not
expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
TURNING THE APPLIANCE ON
Plug the appliance into the mains.
Press the ON/OFF button (19) (when turned on, the air
conditioner starts operating in the same mode as when it was
turned o).
Press the MODE button (21) to select the required mode
COOLING
DEHUMIDIFYING
FAN ONLY
HEATING
On the control panel, the light corresponding to the selected
mode comes on.
For air conditioning/dehumidifying/fan only settings and
programming the timer, see page 8.
19
20
21
22
23
24
