687417
19
Zoom out
Zoom in
Vorherige Seite
1/20
Nächste Seite
24
DISPLAYED MESSAGE POSSIBLE CAUSE REMEDY
The lter (C4) must be replaced. Replace the lter or remove it as described in
section “15. Water softener lter”.
The machine must be descaled. The descaling procedure described in section
“13. Descaling” needs to be performed.
The appliance may request descaling cycles at
very short intervals. This is normal and due to
the appliance’s advanced control system.
Energy saving is enabled. To disable energy saving, proceed as described
in section “6.6 Energy saving ”.
The appliance is connected to a device via
bluetooth.
CLEANING UNDERWAY
PLEASE WAIT
The appliance has detected impurities in its
internal circuits.
Wait for the appliance to be ready for use again
and reselect the required beverage. Contact
Customer Services if the problem persists.
PROBLEM POSSIBLE CAUSE REMEDY
The coee is not hot. The cups were not preheated. Warm the cups by rinsing them with hot
water (Please note! you can use the hot water
function).
The infuser has cooled down because
2/3 minutes have elapsed since the last
coee was made.
Before making the coee, heat the infuser by
rinsing using the rinse function
(see section
“6.1 Rinsing
).
A low coee temperature is set.
Set a hotter coee temperature in the menu (see
section “6.7 Coee temperature
).
The coee is weak or not creamy
enough.
The coee is ground too coarsely. Turn the grinding adjustment dial (A5) one
click anticlockwise towards 1 while the coee
mill is in operation (g. 10). Continue one click
at a time until coee delivery is satisfactory.
The eect is only visible after delivering 2
coees (see section “7.5 Adjusting the coee
mill”).
The coee is unsuitable. Use coee for espresso machines.
The coee is delivered too slowly or a
drop at a time.
The coee is ground too nely. Turn the grinding adjustment dial (A5) one
click anticlockwise towards 7 while the coee
mill is in operation (g. 10). Continue one click
at a time until coee delivery is satisfactory.
The eect is only visible after delivering 2
coees (see section “7.5 Adjusting the coee
mill”).
18. TROUBLESHOOTING
Below is a list of some of the possible malfunctions.
If the problem cannot be resolved as described, contact Customer Services.
19

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für DeLonghi PrimaDonna Class ECAM 550.75 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von DeLonghi PrimaDonna Class ECAM 550.75

DeLonghi PrimaDonna Class ECAM 550.75 Kurzanleitung - Alle Sprachen - 8 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info