Bedienungsanleitung Denon DN-X1700 (Seite 7 von 26) (Englisch)

614628

Zoom out

Zoom in

Vorherige Seite

1/26

Nächste Seite

Getting Started Connections Basic Operations Speciﬁ cations Troubleshooting

Effector Function Fader Start UtilityUSB

Part Names and Functions

For further details on the functions and other aspects of the parts, refer to the page numbers in

parenthesis.

Top Panel

Q7 Q6

E9R0

R2R1E5E2E3E1

MASTER LEVEL control

Adjusts the level of the MASTER outputs.

The LIMITER LED indicates the operating status

of the master output limiter.

• Limiter OFF: LED is off.

• Limiter ON: LED lights up green.

• While limiter is operating: LED lights up red.

Master EFX INS 1, 2 buttons

These buttons enable the various effects of

the selected side, either EFX 1 or EFX 2, to be

obtained for the master output signals.

BOOTH LEVEL control

Adjusts the level of the BOOTH outputs.

USB ASSIGN CH/MASTER button

This is used to switch the assignment destination

of the USB audio input signals supplied from the

computer.

CH:

The signals are assigned to the channels (1 to 4).

MASTER:

The signals are assigned to the master bus and

monitor bus.

MIDI CLOCK START/STOP button

This enables the MIDI clock corresponding to

the BPM value to be sent from the USB MIDI

and MIDI output terminals to the computer

(software) or external device.

START:

Sending the MIDI clock is started.

STOP:

Sending the MIDI clock is stopped.

UTILITY/–USB A/USB B button

This allows the presets to be set and the system

information to be set, changed or referenced.

When it is held down for more than a second,

the USB mode switching screen is opened, and

the USB device mode or USB host mode can

be selected.

BEAT , buttons

(Short) :

The beat/time is decreased.

(Long) :

The beat/time is increased.

TAP LOCK/AUTO/INPUT BPM button

TAP:

When this button is tapped repeatedly, the BPM

(Beats Per Minute) value is measured using the

intervals between the taps.

LOCK:

When the button is pressed once in the auto BPM

mode, the BPM value measured automatically is

locked.

AUTO BPM:

When the button is held down for one second,

the auto BPM mode is established, and the

measured BPM value is displayed.

INPUT BPM:

When it is held down for two or more seconds,

the BPM input mode is established, and the

BPM value can be input directly using the

u BEAT

, buttons. When it is pressed

again, the mode is released.

TIME/BACK button

TIME:

This button is used to select whether to change

the effects produced using the u BEAT ,

buttons on the basis of the number of beats

or time.

BACK (EFX 2 side only):

This is used when returning to the previous

screen while setting screen operations are

being performed.

Effect CUE button

When this button is set to ON, the sound of the

effects (but not the DELAY, ECHO or REVERB

effects) can be monitored even if the effect OFF

status.

EFX SELECT control

This is for selecting the effect to be used.

Refer to the effect functions (page 9).

Parameter ON/OFF button

This is used to control the ON and OFF settings

of the effect parameters.

PARAMETER MIX/MAX control

This is used to adjust the ﬁ lter cutoff frequency

and other effector parameters. The parameters

are changed by the effector selected.

DRY/WET control

Use this to adjust the ratio of original and

effected sound.

Getting Started

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Denon DN-X1700 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Denon DN-X1700

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info