Bedienungsanleitung Denver MT-703 (Seite 36 von 37) (Englisch)

499042

Zoom out

Zoom in

Vorherige Seite

1/37

Nächste Seite

TROUBLESHOOTING

The Player Does Not Power On



The AC Power cord may be loose or not plugged in. Make sure the power cord is secure in the AC socket.

The Battery Pack may be unattached. Make sure the Battery Pack is attached to the unit firmly.

The Power of the Battery Pack may be exhausted. Recharge the Battery Pack.

The unit may be in Standby Mode. Turn the unit on with the remote POWER button or PLAY/PAUSE/ENTER Button on

the player.

There must be a pause between powering the unit down and back on of a few seconds.

Remove Battery Pack or AC Adapter to RESET the player.

The Remote Control Does Not Function



Make sure you re aiming the remote directly at the player s remote sensor, located in the front display.

Make sure there are no obstacles between the remote and the player.

The batteries may be drained. Try changing the batteries in the remote.

You could be using the remote too far away. Try within 4 meters of the player.

Relocate the player to test if these is interference.

’’

Subtitles not shown



Press Remote Control Subtitle button to turn it on.

Subtitles display only recorded on DVDs.

A Specific Disc Does Not Play



The disc may be dirty. Try cleaning the disc.



Make sure the disc is not in upside-down

The region code of the disc may not match that of the player. In this case, the disc cannot be used.

Disc may not be industry standard.

No Sound from TV or Speakers



Once you close the unit s Disc Cover, the unit is still running, but No Sound comes out.

Disc is Dirty or Damaged. Clean the Disc or change to another one.

Volume Control is set to Minimum. Raise up the Volume.

Headphones are connected. Pull out the Headphones.

If you are using a Digital Receiver, check the Dolby/DTS setting in the player s Setup Menu .

Make sure the audio cables connecting the DVD player to your TV or receiver are secure.

The movie is paused. There is no sound during Pause or Search modes.

’

Distorted Picture when Connected to a VCR



This Player is built with Macrovision copy-protection. This will distort the signal when used with VCRs. Connect the player

directly to the TV.

The Picture Appears Stretched or Squeezed



The LCD Mode you are in may be wrong for the movie your re watching. Try changing the LCD setting to suit the movie s

aspect ratio (Standard or Widescreen).

’’

The Video Aspect Ratio may be set wrong for your Television type.

Enter the Setup Menu and select the Video Menu. Try changing the ASPECT setting to 4:3 PS (Pan&Scan) if you are

using a standard TV, or 16:9 WS if your TV is a Wide-Screen type.

No Image on the Built-in Screen



Power isn t on. Turn on the Power.’

Video Mode setting may be in Video output to external monitor mode. Press VIDEO MODE Button to change to Normal

player operation.

Make sure the player is not in LCD Off Mode.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Denver MT-703 Seite 36

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info