534681
67
Zoom out
Zoom in
Vorherige Seite
1/68
Nächste Seite
Dimension BST 768 / SST 768 User Guide
Troubleshooting 67
C. With the glue brush provided in the Startup Kit, clear any
material buildup from each drive by brushing its serrated
drive wheel.
13. Check for Extrusion.
A. Press Forward.
Pull out 6 inches of material from the fixed head housing.
Feed the filament into the drive blocks and look at the tips
to verify material is extruding through both liquefiers.
B. If the filament does not extrude:
i. Stop the motors and return to Step 4.
ii. If, after two tries the material fails to extrude, call your
service provider.
C. If the purge was successful, continue to run both filament
motors forward and slowly swivel the head closed.
D. Once the head is closed, tighten both ¼ turn screws.
E. Verify material continues to extrude through both tips for
an additional 30 seconds, and then press Stop to halt
extrusion.
F. Push Done. The panel displays Is material loaded?
G. Press Yes. The panel displays Exiting maintenance
and you can resume normal operation.
IMPORTANT
While closing the head, be careful not to
crimp the filament, and make sure that
the head wiring doesn’t get pinched
between the swivel head and the rear
head housing.
67

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Dimension SST 768 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info