490373
22
Zoom out
Zoom in
Vorherige Seite
1/24
Nächste Seite
22
PROBLEMS Causes SOLUTIONS
None of the lights are lit.
The machine does not heat
up.
- Power supply problem
- Appliance not plugged in or
On/Off button not pressed
- Other
- Check the plugs and mains.
. Plug in the appliance and press the
On/Off button.
- Go to your local dealer.
The iron does not heat up. - Thermostat dial at the off position
- Other
- Put the dial to the desired tempera-
ture.
- Go to your local dealer.
No steam is produced. - When you call for steam right at
the start,
- Appliance not ready
- The reservoir is empty
- The reservoir is incorrectly inserted
or has not been inserted.
- The anti-scale cartridge has not
been inserted
- The pilot light ANTI-CALC flashes
or is on
- Other
- Press the steam button until steam
does arrive.
- Wait until the on/off pilot light is on
- Fill the reservoir.
- Insert the reservoir and push it fully in.
- Insert an anti-scale cartridge into the
reservoir.
- Change the anti-scale cartridge. Press
the steam button.
- Go to your local dealer.
Water is produced with the
steam.
- The iron soleplate is not hot enough
- Over steaming
- Water condensation in the hose
- Other
- Put the dial to the settings ll
lll.
- Wait for the iron pilot light to go out.
- Press the steam button several times
- Go to your local dealer.
The machine makes a
noise.
- There is no water in the reservoir
- The reservoir is incorrectly inserted
or has not been inserted.
- Other
- Fill the reservoir.
- Insert the reservoir and push it fully in.
- Go to your local approved service
dealer.
Indicator “AUTO-STOP” lit - Auto-Stop activated after 10 minutes
of non-use
- Press the trigger : the pilot light goes
off and the appliance starts heating
again.
ANTI-CALC pilot light
flashes or is lit
- Anti-scale cartridge needs to be
replaced
- Replace the cartridge. Switch the
appliance off and back on. Wait until
the on/off pilot light is permanently
on.
The on / off pilot light
flashes
- The appliance is not ready.
- The appliance is not functional
- Wait until the on/off pilot light is per-
manently on to use the appliance.
- Check if any other pilot light - “AUTO-
STOP” or “ANTI-CALC” - is lit. Follow
the procedures to have these lights
turned off.
What to do if…
22

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

domena-easylife-neo

Suche zurücksetzen

  • Es kommt kein Dampf mehr es piepst nur wen ich auf Dampf drücke was kann das sein Eingereicht am 16-5-2021 11:11

    Antworten Frage melden
  • beim drücken der starttaste erklingt andauernd (kurzem Intervall) ein piepston Eingereicht am 20-4-2019 14:55

    Antworten Frage melden

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Domena Easylife Neo wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info