652304
11
Zoom out
Zoom in
Vorherige Seite
1/14
Nächste Seite
11
AAllaarrmm aanndd eerrrroorr mmeessssaaggeess
The following alarm messages can be generated by the electronics. Refer to
the chapter “
Alarm situations
for further information
DOOR OPEN see status-message “DOOR OPEN”
HIGH ALARM This alarm message appears as soon as the internal temperature
exceeds the given upper alarm limit. A temperature warn alarm is
stored in the Alarm History. The alarm message disappears as soon as
the temperature reaches the upper alarm limit again.
LOW ALARM This alarm message appears as soon as the internal temperature falls
below the given lower alarm limit. A temperature cold alarm is stored in
the Alarm History. The alarm message disappears as soon as the
temperature reaches the lower alarm limit again.
POWERFAIL This message appears if the power supply is interrupted with the
appliance switched on.
A power failure alarm is stored in the alarm history. The alarm message
disappears as soon as the power supply is restored.
If one of the following error messages appears on the display, a fault or a
malfunction has occurred and the affected component must be repaired or
replaced by the service staff.
BAT.1 LOW/FAIL This message appears if the internal main battery is faulty or flat. At
the same time the battery symbol also appears on the display.
BAT.2 LOW/FAIL This message appears if the optional additional battery is faulty or flat.
At the same time the battery symbol also appears on the display.
SENS. REG. FAIL Failure of the control sensor. The appliance continues to run in
“FAILSAFE” mode.
SENS. DIS. FAIL Failure of the display sensor. In this case the display function is taken
over by the control sensor.
SENS. AMB. FAIL Failure of the ambient temperature sensor.
E1 / CFGERROR Configuration fault: Fault in the parameter setting. The appliance does
not start.
E2 Electronics fault. The function of the appliance is stopped.
COM ERROR No communication between interface and mainboard. The function of
the appliance is stopped.
FAILSAFE MODE Serious fault, however the appliance continues to run in "FAILSAFE
mode. i.e. the compressor switches on and off according to the set
rhythm.
11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Dometic ML155 SG wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Dometic ML155 SG

Dometic ML155 SG Bedienungsanleitung - Deutsch - 14 seiten

Dometic ML155 SG Bedienungsanleitung - Holländisch - 14 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info