Bedienungsanleitung Durabrand CD2158 (Seite 2 von 2) (Englisch)

35291

Zoom out

Zoom in

Vorherige Seite

1/2

Nächste Seite

811-215891-011

Printed in China

- 10 -- 9 -

- 8 -

1. SKIP/SEARCH button

2. REPEAT button

3. SKIP/SEARCH button

4. DISC SKIP button

5. PLAY/PAUSE button

6. STOP

button

USING THE REMOTE CONTROL

CORRECTLY

· Point the Remote Control at the REMOTE

SENSOR located on the unit.

· When there is a strong ambient light source,

the performance of the infrared REMOTE

SENSOR may be degraded, causing

unreliable operation.

· The recommended effective distance for

remote operation is about 4 meters (13 feet).

· Remove the protective plastic

tab before operating the remote

control.

1. Open the battery door.

2. Insert one CR2025 (3V) size battery.

BATTERY REPLACEMENT

When battery becomes weak, the operating distance of the Remote Control is greatly

reduced and you will need to replace the battery.

NOTE:

If the Remote Control is not to be used for a long time, remove the battery to avoid

damage caused by battery leakage corrosion.

WARNING: Do not dispose of battery in fire, battery may explode or leak.

REMOTE CONTROL

· To change battery

5 CD HOME STEREO SYSTEM

MAINTENANCE

CLEANING CD

If the CD skips or will not play, the disc may need to be cleaned.

Before playing, wipe the disc from the centre out with a cleaning

cloth. After playing, store the disc in its case.

CLEANING THE UNIT

Do not use volatile chemicals on this unit. Clean by lightly wiping with a soft cloth.

IMPORTANT NOTE

· If an abnormal display indication or an operating problem occurs, disconnect the AC

power cord. Wait at least 5 seconds, then reconnect it .

· Before transporting the unit, take out all discs from the CD tray.

SPECIFICATIONS

Power consumption: 15W

Power source: AC 120V 60Hz

Specifications are subject to change without notice.

PROBLEMS

GENERAL

No sound

No sound from one channel or

unbalance left an right volume

Reversed left and right sound

Lack of bass sound or apparently

imprecise physical location of

musical instruments

Severe hum or noise

Disc in place but unit won’t play

Disc skips

RADIO

Poor FM reception

Poor AM/MW reception

ITEMS TO CHECK

· Turn VOLUME clockwise.

· The headphones are connected.

Disconnect them.

· Check the speaker connections of the

inoperative channel.

· Check the speaker cord connection and

speaker location.

· Check the speaker connection for proper

phasing.

· The TV or VCR is too close to the stereo

system. Separate the stereo system from the

TV or VCR.

· Make sure AC power plug is secure in the

outlet, and outlet has power.

· Make sure FUNCTION selector is set to CD.

· Make sure disc label is facing up.

· Make sure disc is clean.

· Pause mode is activated.

· Disc may be damaged or dirty; check disc.

· Make sure the unit is on a secure spot.

Vibration or jarring can cause the disc to skip.

· Make sure FM antenna wire is unwound.

· Electrical interference in your home can cause

poor reception. Move the unit away from

sources of interference (especially those with

motors and transformers).

· Reposition or turn the main unit for better

reception.

TROUBLE SHOOTING GUIDE

To repeat the whole disc

· Press the REPEAT button until ONE DISC indicator lights up and the current disc will

be played repeatedly starting from the currently playing point.

To repeat all discs

· Press the REPEAT button until ALL DISC indicator lights up.

To cancel repeat play

· Press the REPEAT button until all indicators turn off.

• Open the CD storage door and put CD into the CD storage, maximum six CDs.

DISC

TRACK

DISC

TRACK

DISC

TRACK

REPEAT PLAYBACK

DURING PLAYBACK MODE

To repeat the current track

· Press the REPEAT button until ONE SONG indicator lights up and the currently playing

track will be played repeatedly until the STOP

button is pressed.

DISC

TRACK

USING THE CD STORAGE

To stop playing:

(a) For a moment only, press PLAY/PAUSE button and the track no. will flash.

Press this button again to resume playing.

(b) Press the STOP button.

Note:

The

SKIP/SEARCH buttons can only be used to choose a track of the current disc.

To choose a track of another disc, DISC SKIP button should be pressed to get to the

desired disc first.

LOCATING A PARTICULAR POINT IN A TRACK

To locate a track in sequence

· To locate the beginning of the current or the preceding track, press reverse skip

button.

· To locate the beginning of the succeeding track, press forward skip button.

· A short period of time will be needed for the disc to read the information of the desired

track before playback can be done.

7. Press the PLAY/PAUSE

button to start playback .

DISC

TRACK

REVERSE FORWARD

Press it once

To locate a particular point in a track

· To move forward at high speed, keep forward search button pressed and release it

at the desired point.

· To move backward at high speed, keep

reverse search button pressed and release

it at the desired point.

· If the current track is searched over, it will continue to search the next track until the

end of the disc is reached. The searching will automatically be stopped. If this happens

during playback, the first track of the next numbered disc will be played.

Note:

Searching and skipping can be done during playback or pause stage but are effective

for the currently selected disc only. Use DISC SKIP button to choose another disc.

REVERSE FORWARD

Keep it pressed

- 7 -

COMPACT DISC PLAYBACK (continued)

Durabrand CD2158 Seite 2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info