Bedienungsanleitung EAL APR035 (Seite 4 von 28) (Deutsch, Englisch, Holländisch, Französisch)

598279

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

3. Mount the license plate on the license plate bracket.

4. Choose a routing path for the camera’s power cable through the vehicle’s body to the

reverse light circuit. If in doubt, seek professional installation assistance.

5. Some vehicles may have a hole available to pass the wire through, such as where the

license plate light is mounted, or you can drill a hole close to where the power cable

is attached to the camera. Once you have chosen where the cable will enter the

vehicle’s body, remove the camera. If you are able to use an existing opening, skip

the next two steps.

6. Before you drill a hole you MUST CHECK and see WHAT IS BEHIND WHERE YOU ARE

DRILLING. If there are any vehicle components, such as electrical parts or fuel

system components behind where you are drilling, you must take whatever

precaution is necessary not to damage them. Remove the license plate and camera

before drilling.

7. After you have drilled the hole, insert the supplied grommet, then pass the camera

cables through the grommet into the vehicle. You must use the grommet to prevent

the metal edge of the hole from cutting the camera cable.

8. Mount the transmitter box inside the trunk. Connect the camera’s power cable and

the transmitter box power cable to the transmitter box.

9. Next you’ll need to find the vehicle’s reverse lights. Turn the vehicle’s ignition key to

the accessory position, engage the parking brake and put the car in reverse. Look at

the vehicle’s tail lights to see where the reverse lights are located, they are the white

lights. To locate the reverse light’s 12V+ wire it will be necessary to gain access to

the rear of the vehicle’s tail light. For help locating the vehicle’s reverse light circuit

contact your vehicle’s manufacturer for vehicle specific wiring diagrams.

10. Once you have located the reverse light circuit you will have to route the transmitter

box power cable to that location. You must securely fasten the power cable to prevent

it from being caught on any vehicle component such as the trunk hinge. Never route

the cable on the outside of the vehicle!

11. The reverse light sockets on most vehicles

have two wires connected to them.

Usually the negative wire is black and the

positive wire is a colored wire. If you are

uncertain about the wiring, you can use a

12 volt multimeter available at most auto

parts stores to determine which is the

positive wire. Follow the manufacturer’s

instructions for the safe use of the

multimeter.

12. After determining which wire is the

positive and which is the negative, turn

off the ignition key, then remove the battery’s negative cable.

13. Splice the red wire using the supplied in-line wire connectors to the reverse light’s

positive (+) wire. Use a set of slip joint pliers to squeeze the TAP and insure good

connection.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

EAL APR035 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info