Bedienungsanleitung Ecm Classika PID (Seite 31 von 34) (Deutsch, Englisch)

669390

Zoom out

Zoom in

Vorherige Seite

1/34

Nächste Seite

ENGLISH

Instruction manual CLASSIKA II / CLASSIKA PID

11 TROUBLESHOOTING

Problem Possible Cause Troubleshooting

The grind is not fine enough

Use a finer grind.

Tamp the ground coffee more firmly.

Reduce the brewing pressure.

The coffee is too old. Use fresh coffee

There is too much chlorine in the

water.

Use a chlorine filter.

The amount of ground coffee is not

enough.

Use the right coffee amount:

Approx. 7 g – 9 g (1/4 ounce) of

coffee for each cup.

Little or no crema on top of the

coffee

The shower screen is dirty. Clean the brewing group.

The grind is too fine.

Increase the grinding degree.

Tamp the ground coffee only

slightly.

Increase the brewing pressure.

Sparse coffee dispensing, only drop

by drop

There is too much ground coffee.

Use approx. 7 g – 9 g (1/4 ounce) of

coffee for every cup.

The grind is not fine enough. Reduce the grind.

The coffee is old. Use fresh coffee.

The amount of ground coffee is not

enough.

Use approx. 7 g – 9 g of coffee for

each cup.

Weak “body”

The shower screen is dirty. Clean the shower screen.

The coffee beans are improper. Use another coffee bean.

The setting of the coffee grinder is

not suited for the coffee beans in

use.

Adjust the coffee grinder (When

changing the coffee beans, changing

the grind may also be necessary.)

Foam instead of crema

The green control lamp is switched

off: there is not enough water in the

water tank.

Refill water.

Water was refilled; the orange

control lamp is switched off.

Switch on/off the machine.

Make sure that the floater in the

water tank is in the correct position.

(The side of the floater with the

magnet point should face towards

the inside of the machine. The

floater itself should be inserted with

the magnet point on the upper part

of the floater side.)

The machine is switched on, but the

machine does not start to work.

The water tank is not fixed properly. Fix the water tank properly.

Portafilter is not fixed properly. Fix the portafilter properly.

Portafilter/ brewing group is

dripping

Group gasket is broken.

Change the group gasket and

shower screen.

If the machine will not be used for a long period of time, it is recommended to

.. clean the brew group (see instructions on page 26). Afterwards, please do not clamp the portafilter back into the

group.

.. empty the boiler. Switch the machine off (power switch in lower position) and open the hot water dispenser. Due to

the boiler pressure, the boiler water is now discharged by the hot water dispenser. Close the steam/ hot water handle

or the hot water lever valve again after emptying the boiler. To restart the machine, see chapter “First use”.

How to froth milk like a “barista”

• If possible, use cold and fresh milk with a fat content of 3.5 %. Even homogenised milk is suitable- if you prefer.

• Use a frothing container (made of metal) with a minimum volume of 0.5 litres. The size of the container should

not be too wide. A narrow and high container is perfect.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Ecm Classika PID Seite 31

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info