Bedienungsanleitung Eiki LC-X85 (Seite 6 von 120) (Englisch)

543729

Zoom out

Zoom in

Vorherige Seite

1/120

Nächste Seite

- 6 -

The AC Power Cord supplied with this projector meets the requirement for use in the country you purchased it.

AC Power Cord for the United States and Canada:

AC Power Cord used in the United States and Canada is listed by the Underwriters Laboratories (UL)

and certified by the Canadian Standard Association (CSA).

AC Power Cord has a grounding-type AC line plug. This is a safety feature to be sure that the plug

will fit into the power outlet. Do not try to defeat this safety feature. Should you be unable to insert

the plug into the outlet, contact your electrician.

GROUND

AC Power Cord Requirement

AC Power Cord for the United Kingdom:

This cord is already fitted with a moulded plug incorporating a fuse, the value of which is indicated on the pin face of the plug.

Should the fuse need to be replaced, an ASTA approved BS 1362 fuse must be used of the same rating, marked thus

ASA

. If

the fuse cover is detachable, never use the plug with the cover omitted. If a replacement fuse cover is required,

ensure it is of the same colour as that visible on the pin face of the plug (i.e. red or orange). Fuse covers are available from

the Parts Department indicated in your User Instructions. If the plug supplied is not suitable for your socket outlet, it should

be cut off and destroyed. The end of the flexible cord should be suitably prepared and the correct plug fitted.

WARNING: A PLUG WITH BARED FLEXIBLE CORD IS HAZARDOUS IF ENGAGED IN A LIVE SOCKET

OUTLET.

The Wires in this mains lead are coloured in accordance with the following code:

Green-and-yellow ············ Earth

Blue ································· Neutral

Brown ······························ Live

As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured markings identifying the

terminals in your plug proceed as follows:

The wire which is coloured green-and-yellow must be connected to the terminal in the plug which is marked by the letter E or

by the safety earth symbol

or coloured green or green-and-yellow.

The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black.

The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red.

WARNING: THIS APPARATUS MUST BE EARTHED.

Connecting the AC Power Cord

This projector uses nominal input voltages of 100–120 V or

200–240 V AC.

The AC outlet must be near this equipment and must be

easily accessible.

CAUTION

Connect the AC power cord (supplied) to the

projector.

To POWER CORD

CONNECTOR on your

projector.

Projector side AC outlet side

For Continental EuropeFor the U.S.A. and Canada For the U.K.

NOTE ON THE POWER CORD

AC power cord must meet the requirements of the country where you use the projector.

Confirm the AC plug type with the chart below and proper AC power cord must be used.

Ground

To the AC Outlet.

(120 V AC)

To the AC Outlet.

(200–240 V AC)

To the AC Outlet.

(200–240 V AC)

KR7BL-A_quick.indb 6KR7BL-A_quick.indb 6 09.8.27 2:34:22 PM09.8.27 2:34:22 PM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Eiki LC-X85 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Eiki LC-X85

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info