Bedienungsanleitung Electronics Line EL-2703 (Seite 5 von 14) (Englisch)

580287

Zoom out

Zoom in

Vorherige Seite

1/14

Nächste Seite

Wireless Supervisor Photoelectric Smoke Detector

Where to Install Your Smoke Detectors in Mobile

Homes and RVs

Mobile homes and RVs built after about 1978 were designed and insulated to be

energy-efficient. In mobile homes and RVs built after 1978, smoke detectors should

be installed as described above. Older mobile homes and RVs may have little or no

insulation compared to current standards. Outside walls and roofs are often made

of non-insulated metal, which can transfer thermal energy flow from outdoors. This

makes the air right next to them hotter or colder than the rest of the inside air.

These layers of hotter or colder air can keep smoke from reaching a smoke

detector. Thereby, install smoke detectors in such units only on inside walls. Place

them between 4 and 6 inches (10 ~ 15 cm) from the ceiling. If you are not sure how

much insulation is in your mobile home or RV, then install the detector on an inside

wall. If the walls or ceiling are unusually hot or cold, then install the detector on an

inside wall. Install one detector as close to the sleeping area as possible for

minimum security, or install one detector in each room for security. Before you

install any detector, please read the following section on “Where not to install your

smoke detectors”.

Where Not to Install Your Smoke Detectors

False alarms occur when smoke detectors are installed where they will not work

properly. To avoid false alarms, do not install smoke detectors in the following

situations:

♦ Combustion particles are by-products of something burning. Do not install

smoke detectors in or near areas where combustion particles are present,

such as kitchens with few windows or poor ventilation, garages where there

may be vehicle exhaust, near furnaces, hot water heaters and space heaters.

♦ Do not install smoke detectors less than 6 meters (20 feet) away from places

where combustion particles are normally present, like kitchens. If a 20-foot

distance is not possible, e.g. in a mobile home, try to install the detector as far

away from the combustion particles as possible, preferably on the wall. To

prevent false alarms, provide good ventilation in such places.

IMPORTANT:

Never try to avoid false alarms by disabling the detector.

♦ Do not mount smoke detectors in the path of fresh air intake. The flow of fresh

air in and out can drive smoke away from the smoke detector; thus reducing its

efficiency. Figure 6 indicates the correct and incorrect locations concerning

this problem.

♦ Near paint thinner fumes.

♦ In close proximity to an automobile exhaust pipe; this will damage the detector.

♦ In damp or very humid areas or near bathrooms with showers. Moisture in

humid air can enter the sensing chamber, then turns into droplets upon

cooling, which can cause false alarms. Install smoke detectors at least 3

meters (10 feet) away from bathrooms.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Electronics Line EL-2703 Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Electronics Line EL-2703

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info