Bedienungsanleitung Elektra Nu-Vista CD - Musical Fidelity (Seite 15 von 17) (Englisch)

633192

Zoom out

Zoom in

Vorherige Seite

1/17

Nächste Seite

Page 15

Basic problem-solving with a CD player is similar to troubleshooting other electrical or electronic equipment. Always check the most

obvious possible causes first, such as the following examples:

Problem Probable Cause Remedy

No power / display Power plug is not inserted into socket correctly Plug in securely into unit’s IEC socket.

No playback when disc is

loaded, “NO DISC” displayed

Disc is loaded with label side down

Incorrect disc type

Dirty disc

Moisture/humidity or cold affecting laser lens

Re-load with label side up

Please load a standard audio CD

Clean disk and try again

Leave unit on for an hour to allow moisture to

evaporate.

No audio output, or output too

low

Incorrect or missing connections Check connections are secure.

No Display Power not on/connected

Display set to “off”

Check mains lead is connected and blue LED

is lit by pushing “PWR/STBY” button.

Press “DISPLAY” button to reactivate display.

Hum Audio connector plug not fully pushed in

Cable Fault

Unsuitable Cable

(e.g. cable grounds not connected)

Insert plug securely

Check cable is connected at both ends.

N.B. some esoteric cables have internal wiring

intentionally disconnected/modified. For best

results on all inputs analogue AND digital,

please use good quality screened coax; signal

and screen directly connected both ends.

Mistracking (sound jumping) Player is receiving vibration or shock

Disc is dirty

Moisture/humidity or cold affecting laser lens.

Move player away from loudspeakers etc.

Clean disc surface

Leave unit on for an hour to allow moisture to

evaporate.

Dropouts in sound Digital input lead not properly connected

Faulty digital input lead

Faulty optical lead

Check input lead is fully secured

Change lead. Please use a good quality

straight-through signal-and-ground phono to

phono lead.

Optical lead breakage. This can occur if the

optical lead is bent into a radius too small.

Avoid tight corners in routing optical leads.

Digital input not working No connection to that input

Incorrect input selected

Wrong data type sent to DAC

Check connection and cable.

Select correct input

Check source digital output is set for “16 bit

stereo PCM” or similar. This particularly

applies to some TVs, most DVD players, and

other home theatre type devices that may give

a MULTICHANNEL digital output. Refer to the

source equipment manual for further

information.

Remote control range has

reduced

Batteries are flat Change batteries for a new set

Control is not pointed directly towards the front

panel of the player

Ensure there is no obstruction between the

remote control and player front

Batteries are running out Change batteries – for a new set

If none of these actions affect a cure, please contact the dealer, or an authorised Musical Fidelity service agent. Remember;

never open the case of the Nu-Vista CD, as this will invalidate the guarantee.

PROBLEMS?

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Elektra Nu-Vista CD - Musical Fidelity Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info