Bedienungsanleitung Elica Eliper (Seite 6 von 6) (Englisch)

471237

Zoom out

Zoom in

Vorherige Seite

1/6

Nächste Seite

Cleaning

The cooker hood should be cleaned regularly (at least with the

same frequency with which you carry out maintenance of the

fat filters) internally and externally. Clean using the cloth

dampened with neutral liquid detergent. Do not use abrasive

products. DO NOT USE ALCOHOL!

WARNING:

Failure to carry out the basic cleaning recommendations of the

cooker hood and replacement of the filters may cause fire

risks.

Therefore, we recommend oserving these instructions.

The manufacturer declines all responsibility for any damage to

the motor or any fire damage linked to inappropriate

maintenance or failure to observe the above safety

recommendations.

Panel

Fig. 2

Attention! Hold the panel with both hands when

dismantling and re-mounting in position to avoid it falling

and causing damage to people or things.

Dismantling:

pull the panel (FRONT SIDE) downward with decision,

unscrew safety knob S and unhook it from the rear hinge.

Cleaning:

Clean the suction panel with the same frequency as the fats

filter using a cloth soaked in neutral liquid detergents.

Avoid the use of products containing abrasives. DO NOT

USE ALCOHOLS.

Montage:

The panel must be hooked at the back and fixed in front fitted

into the pins for the purpose on the surface of the hood.

Attention! always check that the panel is well fixed in its

place.

Grease filter

Fig. 3

Traps cooking grease particles.

This must be cleaned once a month (or when the filter

saturation indication system – if envisaged on the model in

possession – indicates this necessity) using non aggressive

detergents, either by hand or in the dishwasher, which must

be set to a low temperature and a short cycle.

When washed in a dishwasher, the grease filter may discolour

slightly, but this does not affect its filtering capacity.

To remove the grease filter, pull the spring release handle.

Charcoal filter (filter version only)

Fig. 4

It absorbs unpleasant odours caused by cooking.

The saturation of the activated charcoal occurs after more or

less prolonged use, depending on the type of cooking and the

regularity of cleaning of the grease filter.

In any case it is necessary to replace the cartridge at least

every four mounths.

The carbon filter may NOT be washed or regenerated.

Remove the grease filters.

Fit the charcoalfilters over the motor.

Align the pins R on the cowl with the slots S, then turn the

filter clockwise until it locks in place.

Reverse the above procedure to remove the charcoal filters.

Refit the grease filters.

Replacing lamps

Fig. 5

Disconnect the hood from the electricity.

Warning! Prior to touching the light bulbs ensure they are

cooled down.

• Use a small screwdriver as a lever on the borders of the

lamp in order to remove the lightbulb.

• Slide out the lightbulb to be replaced and replace with a

new 12V 20W MAX 30° Ø35 12V GU4.

• Carry out the replacement and mount the new lightbulb

by following instructions in the reverse.

If the lights do not work, make sure that the lamps are fitted

properly into their housings before you call for technical

assistance.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Elica Eliper Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info