667131
16
Zoom out
Zoom in
Vorherige Seite
1/19
Nächste Seite
33
buttons will always have priority over the commands received
from the telephone interface.
If you press the or button on the chronostat, the device
will change its status and the ‘ ’ icon will flash to indicate that
the interface command has been overridden by a command input with
a control button.
The ‘ icon will stop flashing if the telephone interface sends the
chronostat the same command as the one made with the button or
if the telephone interface is reset. In such a case the status set by
means of the control button will not be changed and the chronostat
will be ready to receive a new command.
IMPORTANT
If an Off command is sent to the chronostat via the telephone
interface (contact open), it is a good idea to check that the
command has been executed by the chronostat by carrying out
the following realignment procedure:
1. Using the functions of the telephone interface, check that the
contact is open, sending an Off command if necessary.
2. Send a command to the telephone interface to close the
contact (the chronostat will turn on).
3. Using the functions of the telephone interface, check that the
contact is closed.
4. Send a command to the telephone interface to open the
contact (the chronostat will turn off).
During this sequence no commands should be input with
the control buttons as they have priority over the interface
commands.
TECHNICAL CHARACTERISTICS
Power supply: 2 x 1.5V, alkaline batteries (Type AA)
Battery life: > 2,5 years
Frequency: 868,150 MHz
Modulation: GFSK
Effective radiated power (ERP): < 1 mW
Antenna type: Internal
Max. receiver distance: >300 m in free air
>50 m in buildings (depending on
the building and environment)
Room temperature
Regulation range:
comfort: 5,0 .. 35,0°C
economy: 5,0 .. 35,0°C
Hysteresis: 0,2°C adjustable 0,1 .. 5,0 °C
Sensor type: NTC 4K7 ohm ±1% @ 25°C
Resolution: 0,1°C (T > 0,0°C)
0,2°C (T < 0,0°C)
Range: -9,9°C .. +50,0°C
Precision: ±1,0°C
Floor temperature (external sensor)
Regulation range: Lower limit: 10 .. 30°C
Upper limit: 35°C .. 50°C
Sensor type: NTC 4K7 ohm ±1% @ 25°C
Resolution: 0,1°C (T > 0,0°C)
0,2°C (T < 0,0°C)
- ENGLISH -
16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Emmeti N-CTA-W wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info