26
WARNING
- To determine the correct position one must ensure that the radio
signals transmitted are correctly received by the receiving unit.
- To adjust properly room temperature, install the thermostat far from
heat sources, airstreams or particularly cold walls (thermal bridges).
When the remote sensor is used in conjunction with the thermostat,
then this note is to be applied to the remote sensor itself.
- For remote version all wirings must be made using wires with 1,5 mm²
minimum section and no longer than 3 m. Do not use same duct for
signal wires and mains.
- Installation and electrical wirings of this appliance must be made by
qualified technicians and in compliance with the current standards.
In the view of a constant development of their products, the manufacturer reserves the
right for changing technical data and features without prior notice.
The consumer is guaranteed against any lack of conformity according to the European
Directive 1999/44/EC as well as to the manufacturer’s document about the warranty
policy. The full text of warranty is available on request from the seller.
ENGLISHPORTUGUÊS DEUTSCH ITALIANOFRANÇAISESPAÑOL
