Bedienungsanleitung Emporia BPM-V20-B (Seite 31 von 32) (Englisch)

792171

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

›EMC DECLARATION

1) * This product requires special attention with regard to EMC (electromagnetic compatibility) and must be installed and commissioned in accordance with the

EMC information provided. This device can be aected by portable and mobile radio frequency (RF) communication devices.

2) * Do not use a mobile phone or other devices in the vicinity of the blood pressure monitor that emit electromagnetic elds. This can lead to malfunction.

3) * Warning: This blood pressure monitor has been thoroughly tested and inspected to ensure proper performance and operation!

4) * Warning: This device must not be used in the vicinity of other devices. If use alongside other devices is required, the blood pressure monitor should be

observed to verify normal operation.

Guidance and manufacture’s declaration – electromagnetic emission

The device is intended for use in the electromagnetic enviroment specified below.

The customer of the user of the device should ensure that it is used in such an environment.

Emission test Compliance Electromagnetic environment – guidance

RF emissions CISPR 11 Group 1

The device use RF energy only for its internal function.

Therefore, its RF emissions are very low and are not

likely to cause any interference in nearby electronic

equipment.

RF emissions CISPR 11 Class B The device is suitable for use in all establishments,

including domestic establishments other than domestic

and those directly connected to the public low-voltage

power supply network that supplies buildings used for

domestic purposes.

Harmonic emissions IEC61000 - 3 -2 Not applicable

Voltage fluctuations / flicker emissions

lEC61000-3- 3 Not applicable

Recommended separation distances between portable and mobile RF communications equipment and the device

The device is intended for use in an electromagnetic environment in which radiated RF disturbances are controlled. The customer or the user of the device can

help prevent electromagnetic interference by maintaining a minimum distance between portable and mobile RF communications equipment (transmitters)

and the device as recommended below, according to the maximum output power of the communications equipment.

Rated maximum output power

of transmitter (W)

Separation distance according to frequency of transmitter (m)

150 kHz to 80 MHz

d = [ 3.5

–

V1 ] √P

80 MHz to 800 MHz

d = [ 3.5

–

V1 ] √P

800 MHz to 2 GHz

d = [ 7

–

V1 ] √P

0.01 0.12 0.12 0.23

0.1 0.38 0.38 0.73

11.2 1.2 2.3

10 3.8 3.8 7.3

100 12 12 23

For transmitters rated at a maximum output power not listed above, the recommended separation distance d in metres (m) can be estimated using the

equation applicable to the frequency of the transmitter, where P is the maximum output power rating of the transmitter in watts (W) according to the

transmitter manufacturer.

Note 1: At 80 MHz and 800 MHz, the separation distance for the higher frequency range applies.

Note 2: These guidelines may not apply in all situations. Electromagnetic propagation is affected by absorption and reflection from structures, objects

and people.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Emporia BPM-V20-B Seite 31

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Emporia BPM-V20-B

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info