ENDURO
®
autoSteady 40
Ref: AS101-UM-TKI-0114-Rev. A
Check the distance between the remote control and the caravan is not more than 5 meters. If there is no signal
between the remote control and the control unit, the autoSteady system will not function at all and the green
LED on remote control will blink.
Check if there is any distortion signal (other transmitter, high power cables, Wifi etc.) that disturbs a good
communication between remote control and control unit. If there is no good communication between the
control unit and remote control, the autoSteady system will not function and the green LED on remote control
will blink.
In general, all error messages will reset automatically after one minute. If this is not the case, reset the
electronics of the autoSteady system by switching off the autoSteady system via the isolation switch and the
remote control for at least 15 seconds and then turn them on again.
Spindle will not turn, motor rotates freely:
The motor or gear is broken, or the connect-pin between the motor and spindle is broken, please contact your
EN
DURO
®
autoSteady supplier
In case of any doubt, please contact your EN
DURO
®
supplier.
